Automotive Manual, Car Parts and News

This kit allows the owner of any BMW to attach a front license plate to their BMW without the need to drill holes. BMW has always attached the front license plate by drilling the front bumper and permanently mounting the plastic license plate bracket to the front bumper with screws. The ‘NO HOLES’ kit mounts […]

[Read more →]

SUSPENSION - FRONT (4WD COIL SPRING) 1994 SUSPENSION Ford Motor Co. Suspension - Front (4WD) Coil Spring
Removal (Bronco & F150)
1. Using Torx Bit (T-25), remove 5 bolts from cap assembly. Remove cap assembly. See Fig. 5 . DO NOT
drop spring, ball bearing, bearing race or spring retainer.
2. Remove rubber sealing ring and seal bridge retainer. […]

[Read more →]

The mounting procedure outlined below covers the 2004 and Newer Nissan Titan trucks. You will need to refer to the illustrations and familiarize yourself with each of the undercarriage components and their relative position to each other. Then proceed as follows:
1. Begin by removing the front skid plate (if applicable). There should be (4) bolts […]

[Read more →]

Instructions Procedure:
• Lift vehicle and remove wheels.
• Remove nut (1) and bolt (2)
• Remove lower absorber mounting bolt (3).
• lower wishbone (4) by prying downward.
• Remove inside paneling in the trunk.
• Remove nuts (5 and 6).
• Remove complete shock assembly by pulling downward.
• Disassemble shock assembly using spring compress or. when disassembling ref er to […]

[Read more →]

41-53 GM Stepside: Install one hinge to the passenger bed side rear stake pocket with two 5/16” hex head bolts, one lock washer, and one nut. The upper bolt threads into a nut welded inside the stake pocket. Leave loose for now. Fit the tailgate onto this hinge. Place the second hinge into the opposite […]

[Read more →]

STEP 1. Raise and safely support the vehicle at least 1-2 feet off the ground. Remove the nut and lock-washer holding the downshift linkage onto the downshift lever shaft. The downshift lever is the outer lever on C-4 transmissions. Pull the lever off the shaft and allow the linkage to hang free. Remove and discard […]

[Read more →]

1. Before beginning the installation, please read the instructions thoroughly and verify that the hardware kit is complete. If any of the pieces listed above are missing, call you distributor immediately to obtain the necessary items.
2. Identify your product´s components. Tips: The front of the side bar has the step pad farther from the edge […]

[Read more →]

Before installation of the Air Ride unit, prepare a smooth, flat, hard surface and have all tools and equipment needed for the job. Chock the front wheels of the truck, to prevent it from rolling forward or rearward. Place a jack on each side of frame ahead of the rear springs, front bolts.

[Read more →]

Installation:
1. Secure and properly block the tires of vehicle on a level concrete or asphalt surface.
2. Open hood, remove the upper shock nuts and retainers, remove the 3 nuts on the upper shock tower brackets.
3. Jack up front of vehicle and install jack stands under frame behind the lower link rear brackets. Remove tires and […]

[Read more →]

1) Front brackets are identical and are simply turned 180 degrees out so face of bracket is facing outside of truck.
2) Bars can be mounted either side and are identical.
3) Body mount torque is 65 ft.-lbs.
4) Holes in rocker panel are usually covered with black or grey tape from manufacturer

[Read more →]