Automotive Manual, Car Parts and News

Step 1: Position truck on a flat surface and lift front wheels off of ground using jack stands or a (2) two post lift if available, and remove the driver’s side front wheel. Next loosen and remove the Upper ball joint nut, Tie rod nut and Sway bar nut on the same side of the […]

[Read more →]

Get ready to install coil spring leveling kit.
1. Lift front wheel assemblies.
a. If so equipped, remove two caps (4) from front wheels (5)
b. Loosen eight lug nuts (6) each from two front wheels (5).
c. Using a hydraulic jack, slowly lift front of vehicle so that two front tires (7) are three to five inches off […]

[Read more →]

This coil spring lift kit should only be installed on vehi- cles in good working condition. Before installation, the vehicle should be thoroughly inspected for evidence of corrosion or deformation. This coil lift kit should not be installed on any vehicle that is suspected to have been in a collision or misused. Failure to observe […]

[Read more →]

Ride Height
1. Measure ride height with the vehicle supporting its own weight on level ground. To settle the suspension, the vehicle should be driven forward at least 10 feet immediately prior to taking these measurements. Ride height is the measurement from the center of the axle straight up (vertical) to the fender lip. Record this […]

[Read more →]

Proper installation of this kit requires knowledge of the factory recommended procedures for removal and installation of original equipment components. We recommend that the factory shop manual and any special tools needed to service your vehicle be on hand during the installation. Installation of this kit without proper knowledge of the factory recommended procedures may […]

[Read more →]

Ride Height
1. Measure ride height with the vehicle supporting its own weight on level ground. To settle the suspension, the vehicle should be driven forward at least 10 feet immediately prior to taking these measurements. Ride height is the measurement from the center of the axle straight up (vertical) to the fender lip. Record this […]

[Read more →]

Park your truck on flat level surface. Chock the rear wheels. Loosen front lug nuts. Raise the front with a floor jack. Support the frame with jack stands. Remove front wheels.
NOTE : ALWAYS USE JACK STANDS - NEVER RELY ON JACKS ONLY!!
1) Starting on the drivers side, locate the height adjusting bolt at the rear […]

[Read more →]

This Ultra S kit contains underdrive crank pulley Part# 0208106 with steel timing trigger ring and 4 mounting bolts.. Check that the part number matches the part number engraved on the back of the pulley. If the part numbers or quantity of parts do not match, do not install the pulley and call the dealer […]

[Read more →]

Step 1
Raise Vehicle, and R vehicle, and R vehicle, and Remove Wheels
A level, stable and clean surface, suitable for supporting the vehicle on jack-stands, should be used for the installation.
Warning: Never leave any vehicle support vehicle supported with only a jack. Always use jack-stands.
Break loose the lug nuts on both rear wheels before jacking up […]

[Read more →]

These instructions are for the Audi TT and Volkswagen Mark IV chassis vehicles. The photos shown are of an Audi TT. The Volkswagen applications use the same caliper brackets, rotors and hats, and the caliper bodies are identical, so the installations are very similar on all vehicles. The one main difference is the brake lines, […]

[Read more →]