Automotive Manual, Car Parts and News

Step 1 - Unpack QuickLIFT kit and verify contents.
Remove all items from the packing tube. You should have the following before beginning:
* (2) Gas Springs - Be sure to cycle them a few times before installing!
* (4) 3/16″ gold shafted rivets - for hood brackets
* (2) 3/16″ Multi-grip rivets - center hole of hood brackets
* […]

[Read more →]

Let’s start with the rear door:
First, unscrew the two Philips head machine screws that hold the flip-out window latch to the door frame. Swing the latch toward the window to get it out of the way. Then the upper trim panel pulls straight away from the door. You may want to slide a thin screwdriver […]

[Read more →]

List of tools and additional parts required
Masking tape, clear tape, black mastic, hammer, centre punch
Assorted screw drivers, sockets and spanners 103mm (4”) hole saw
Assorted drill set, wet / dry sand paper, ½ round file, small square file, Zinc rich primer.

[Read more →]

Follow carefully the instructions listed on these pages and use the template provided, do not over tighten bolts. Do not use silicone on any connections, use mastic. Ensure that safe work practices are followed when installing your Airflow Snorkel. Protective ear and eye wear should be worn at all times when using power tools.

[Read more →]

Pre-fit all pieces to the vehicle. Once you are assured that you have the right aero kit you may proceed. If you don’t, please call Stillen right away. We highly recommend using masking tape anywhere the aero kit may be touching the vehicle body to prevent scratches during the pre-fit. Do any sanding, filing, or […]

[Read more →]

Tonneau cover unpackaging and vehicle preparation.
1. Remove the two zip t ies that are holding the gas springs and the hardware kit.
2. Remove the frame’s cross bar. This will require loosening four phillips head screws and three 7/16” nylock nuts.
3. Remove the two phillips head screws holding the front frame brackets.
4. Remove the hinge assembly […]

[Read more →]

Step 1 - Unpack QuickLIFT kit and verify contents.
Remove all items from the packing tube. You should have the following before beginning:
* (2) Gas springs (RT-QL-200-7A) - Be sure to cycle them a few times before installing.
* (8) 3/16″ Multi-grip Rivets - #1 Short MG.
* (2) Large steel brackets - fender
* (2) Small steel brackets […]

[Read more →]

Follow carefully the instructions listed on these pages and use the template provided, do not over tighten bolts. Do not use silicone on any connections. Use urethane Ensure that safe work practices are followed when installing your Airflow Snorkel. Protective ear and eye wear should be worn at all times when using power tools.

[Read more →]