Automotive Manual, Car Parts and News

Installation of this baseplate requires removing the bumper.
1. Read the General Instruction Sheet included with this baseplate.
2. The baseplate mounts to the vehicle using the four bolts that mount the bumper to the frame and two bolts into the frame. All bolts are provided with the baseplate.
3. The bumper of the pickup will be removed […]

[Read more →]

PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. DO NOT ATTEMPT INSTALLATION ALONE; PERSONAL INJURY OR DAMAGE TO THE TRUCK MAY RESULT.
2. From underside of vehicle, remove the passenger and driver side splash shield and the air valance.
3. Measure and mark 12 ―” from the outside and […]

[Read more →]

Installation of the side strakes should taoe approximately 30 minutes per side to complete following these simple instructions. Allow yourself plenty of time. There is no need to rush and potentially make mistakes that could lead to additional work or worse, damage to your new strakes. Please read through these instructions entirely before beginning the […]

[Read more →]

The drop link is fully rose-jointed and is a direct replacement for the original unit. Instead of using rubber bushes to provide the articulation, it uses two rod ends to provide smoother movement — and an end to regular bush replacement. NOTE: the front and rear drop links are identical and these fitting instructions cover […]

[Read more →]

It is recommended that this set be professionally installed if you are unfamiliar with this type of work, and a factory service manual be purchased prior to performing any work on your vehicle for proper disassembly, reassembly and torque specs. These instructions are intended for bushing removal and install of Energy Suspension polyurethane bushings, once […]

[Read more →]

Powerchip technology enhances your Mazda to its ultimate level, delivering faster, smoother acceleration in all driving conditions. Whether you enjoy a leisurely weekend cruise or a hard racetrack drive – there is no easier and more effective way to release the potential from your Eunos 30X 1.8 V6. The following information is an overview of […]

[Read more →]

It is recommended that this set be professionally installed if you are unfamiliar with this type of work, and a factory service manual be purchased prior to performing any work on your vehicle for proper disassembly, reassembly and torque specs. These instructions are intended for bushing removal and install of Energy Suspension polyurethane bushings, once […]

[Read more →]

- Loosen AFM clamp (1) securing the crossover tube (4) to the AFM
- Unplug the AFM connector (2) by pushing down on the tab and pulling away. Do not pull on the wires.
- Remove the three plastic clips securing the air temp sensor wire to the air box.
- Separate the crossover tube (4) from the […]

[Read more →]

Park your truck on flat level surface. Chock the rear wheels. Loosen front lug nuts. Raise the front with a floor jack. Support the frame with jack stands. Remove front wheels.
NOTE : ALWAYS USE JACK STANDS - NEVER RELY ON JACKS ONLY!!
1) Starting on the drivers side, locate the height adjusting bolt at the rear […]

[Read more →]

Getting started
- Chock the other 3 wheels on both sides
- Release handbrake
- Put the gearbox into neutral
- Loosen wheel nuts
- Jack up the car
- Remove wheel nuts + wheel
- Place jack-stand under car for safety

[Read more →]