Automotive Manual, Car Parts and News

RSS Feed

Free PDF Download, Car Parts and Automotive News

Jackson Racing Cold Air Induction 1.6 Installation Instructions

November 30th, 2010 · No Comments

Thank you for choosing Jackson Racing for your Miata performance parts. You will find the Jackson Racing Cold Air Induction™ Kit easy to install. Stock components removed should be placed in boxes or plastic bags and marked for easy identification. Access to a Mazda service manual is always helpful when working on your Miata. (Miata [...]

[Read more →]


06-Current Mazda MX-5 Miata Convertible Curl Manufacturing P/N.11208

November 29th, 2010 · No Comments

INSTALLATION STEPS
1. Locate center of lower rear fascia, trim a 1 3/4″ by 3/4″ opening as shown in the Fascia Trim Diagram above.
2. For ease of installation, lower muffler by removing four (4) rubber isolators.
3. Remove the plastic caps on the outside of each frame rail. Enlarge access holes to allow for CM-SP2 spacers and [...]

[Read more →]


2006-2007 Mazda MX-5 Popping Noise from Radio When Passing Over Bumps

November 29th, 2010 · No Comments

2006-2007 MX-5 vehicles with VIN from JM1 NC**** ** 100288 to 116742 (produced June 20, 2005 to April 8, 2006)
Some vehicles may experience a popping noise from AM radio stations when passing over bumps. This symptom will be present only when AM band is selected. Due to insufficient crimping, poor contact occurs at antenna feeder [...]

[Read more →]


2006-2007 Mazda MX-5 Water Accumulation In Footwell / Plugged Soft Top Drains

November 29th, 2010 · No Comments

2006-2007 MX-5 soft top models with VINs lower than JM1 NC**** ** 131736 (produced before November 20, 2006)
Some vehicles equipped with the folding soft top may experience water accumulation in the foot wells due to the soft top drains becoming clogged with leaves and other debris.
As mass production changes:
- A filter has been added to [...]

[Read more →]


Mazda MX5 Brake Discs and Pads Workshop

November 28th, 2010 · No Comments

This routine servicing task is well within the grasp of the DIY enthusiast. Here’s how to do it and save on labour charges. Replacing worn brake pads and discs is a very simple task and will transform your car if these products are past their best. All that’s required is a spare afternoon, some basic [...]

[Read more →]


2006 Mazda MX-5 2.0L Intake System Installation

November 26th, 2010 · No Comments

PRE INSTALLATION for 2006 Mazda MX-5 2.0L Intake System
1. Read entire instruction sheet before proceeding.
2. Run OBD II diagnostics and repair or replace any malfunctioning components before installation.
3. Make sure vehicle is parked on a level surface and set the parking brake.
4. Disconnect both battery terminals.
5. If engine has run within the past two hours [...]

[Read more →]


2007 Mazda MX-5 Miata Power Retractable Hard Top

August 18th, 2010 · No Comments

Adding a new dimension to the Mazda MX-5 without diminishing its driving joy is no mean feat. The MX-5 is, after all, the icon of two-seat roadsters, the car that reinvented the category in 1989 and nurtured the elemental sports car through three generations. Fiddling with the MX-5 – the world’s best-selling two-seat roadster – [...]

[Read more →]


Mazda MX-5 Miata Mazdaspeed Complete Report Manual

August 18th, 2010 · No Comments

Complete Report series for Mazda MX-5 Miata: The biggest change for the Miata since its 1989 inception came in mid-2004 with the introduction of the 178-hp, turbocharged Mazdaspeed MX-5. Speed now joins lively handling as part of the Miata’s timeless appeal. The 1.8-liter four- cylinder engine makes peak horsepower at 6000 rpm, and 166 lb-ft [...]

[Read more →]


Mazda MX-5/Eunos Front/Rear anti-roll bar drop link Installation Instructions

November 7th, 2009 · No Comments

The drop link is fully rose-jointed and is a direct replacement for the original unit. Instead of using rubber bushes to provide the articulation, it uses two rod ends to provide smoother movement — and an end to regular bush replacement. NOTE: the front and rear drop links are identical and these fitting instructions cover [...]

[Read more →]


Mazda MX-5, RX-8 Hotchkis Front Sway Bar Installation

November 1st, 2009 · No Comments

Raising Vehicle
Removal of the front sway bar should be done at ride height, so it is recommended that the vehicle be raised by a flat alignment style rack, or place the front of the vehicle on ramps and securely block the rear wheels.
Remove front Splash Guard
To access the front sway bar you will need to [...]

[Read more →]




?>