Automotive Manual, Car Parts and News

Park your car on a level surface and block the wheels. Engaging and disengaging the emergency brake and gear shift is required for installation.
-Remove the 2×8mm bolts located under the rubber pad in the center console compartment.
-Remove the shift knob by rotating it counter clockwise.
-Remove center section of the console, held in by pressure clips […]

[Read more →]

The cradle fits passenger side front.
This takes a 10in case battery eg. EXIDE ED50 65amp/hour
Fits in the corner behind the headlight on the passenger side.
Remove rear bolt from flat in-between head light & air cleaner
Move wiring loom from same position

[Read more →]

In order to install DDE Plus into the Mazda Protégé 5, there are several steps that will be required. None of them is particularly difficult although it may appear so in the beginning. The actual work time to perform the installation is about 4 hours. But with breaks, glue set-up time and the tendency to […]

[Read more →]

GROM adapter for the Mazda 08.5+ uses IPOD mode of your stereo. You will lose the use of the external factory IPOD to gain the use of your USB, iPod or MP3.
Preparation
1. It is recommended to disconnect the car battery before performing the installation.
Turn off the car engine and remove the key from the ignition.
2. […]

[Read more →]

Read instructions before assembling. Fasteners should be finger tight until instructed to tighten according to the torque chart. Use standard methods and practices when attaching snowplow including proper personal protective safety equipment.
PUSHBEAM HEIGHT
The recommended pushbeam height for this undercarriage assembly is 10-1/2″ from the center of the pushbeam to level ground. DO NOT exceed […]

[Read more →]

We have designed AuxMod to be reasonably easy to use and install, as well as safe. This guide will outline the correct installation procedures to follow when installing the unit in a Mazda Radio. This guide assumes that you have the capability to remove and install the radio from your vehicle and that you can […]

[Read more →]

It is recommended that this set be professionally installed if you are unfamiliar with this type of work, and a factory service manual be purchased prior to performing any work on your vehicle for proper disassembly, reassembly and torque specs. These instructions are intended for bushing removal and install of Energy Suspension polyurethane bushings, once […]

[Read more →]

PRE INSTALLATION
1. Read entire instruction sheet before proceeding.
2. Run OBD II diagnostics and repair or replace any malfunctioning components before installation.
3. Make sure vehicle is parked on a level surface and set the parking brake.
4. Disconnect both battery terminals.
5. If engine has run within the past two hours let it cool down.
6. Chock the rear […]

[Read more →]

Some vehicles may have a MIL illumination with DTC’s P0441, P0442, P0455, or P0456 stored in memory. To determine the location of the evaporative system leak, follow the repair procedure below.
P0441 - Evaporative emission control system incorrect purge flow
P0442 - EVAP system leak detected (small leak)
P0455 - EVAP system leak detected (gross leak)
P0456 - EVAP […]

[Read more →]

The adapter is provided for connection of an iPod (with a Dock connector) to a genuine Mazda audio system. The iPod can be operated from a genuine Mazda audio system in the same way as an externally connected CD changer.
iPod models (software) which can be connected and used with the audio system are as follows:
• […]

[Read more →]