Automotive Manual, Car Parts and News

In order to install DDE Plus into the Mazda Protégé 5, there are several steps that will be required. None of them is particularly difficult although it may appear so in the beginning. The actual work time to perform the installation is about 4 hours. But with breaks, glue set-up time and the tendency to [...]

[Read more →]

GROM adapter for the Mazda 08.5+ uses IPOD mode of your stereo. You will lose the use of the external factory IPOD to gain the use of your USB, iPod or MP3.
Preparation
1. It is recommended to disconnect the car battery before performing the installation.
Turn off the car engine and remove the key from the ignition.
2. [...]

[Read more →]

Read instructions before assembling. Fasteners should be finger tight until instructed to tighten according to the torque chart. Use standard methods and practices when attaching snowplow including proper personal protective safety equipment.
PUSHBEAM HEIGHT
The recommended pushbeam height for this undercarriage assembly is 10-1/2″ from the center of the pushbeam to level ground. DO NOT exceed [...]

[Read more →]

We have designed AuxMod to be reasonably easy to use and install, as well as safe. This guide will outline the correct installation procedures to follow when installing the unit in a Mazda Radio. This guide assumes that you have the capability to remove and install the radio from your vehicle and that you can [...]

[Read more →]

It is recommended that this set be professionally installed if you are unfamiliar with this type of work, and a factory service manual be purchased prior to performing any work on your vehicle for proper disassembly, reassembly and torque specs. These instructions are intended for bushing removal and install of Energy Suspension polyurethane bushings, once [...]

[Read more →]

PRE INSTALLATION
1. Read entire instruction sheet before proceeding.
2. Run OBD II diagnostics and repair or replace any malfunctioning components before installation.
3. Make sure vehicle is parked on a level surface and set the parking brake.
4. Disconnect both battery terminals.
5. If engine has run within the past two hours let it cool down.
6. Chock the rear [...]

[Read more →]

Some vehicles may have a MIL illumination with DTC’s P0441, P0442, P0455, or P0456 stored in memory. To determine the location of the evaporative system leak, follow the repair procedure below.
P0441 – Evaporative emission control system incorrect purge flow
P0442 – EVAP system leak detected (small leak)
P0455 – EVAP system leak detected (gross leak)
P0456 – EVAP [...]

[Read more →]

The adapter is provided for connection of an iPod (with a Dock connector) to a genuine Mazda audio system. The iPod can be operated from a genuine Mazda audio system in the same way as an externally connected CD changer.
iPod models (software) which can be connected and used with the audio system are as follows:
• [...]

[Read more →]

Ford Explorer/Mercury Mountaineer door panel removal
1. Open door and lower window.
2. Remove two screws above door handle.
3. Starting from right side, remove plastic trim from behind door handle.
4. Dislodge snaps from behind the left, right, and bottom edge of door panel.
5. Lift door panel off of door.
6. Dislodge window control panel and pass through opening [...]

[Read more →]

Installation of this baseplate requires removing the bumper.
1. Read the General Instruction Sheet included with this baseplate.
2. The baseplate mounts to the vehicle using the four bolts that mount the bumper to the frame and two bolts into the frame. All bolts are provided with the baseplate.
3. The bumper of the pickup will be removed [...]

[Read more →]