Automotive Manual, Car Parts and News

The installation of the AEM ECU on the 1993-1997 3000GT/Stealth uses the stock sensors and actuators. The base maps are automatically installed in the base calibrations directory in the AEMPro directory on your computer. The 91-93 and 94-97 installations use a different base map due to wiring / model feature changes. The EMS hardware is […]

[Read more →]

INSTALLATION
1) Disconnect the vehicle’s negative battery cable.
2) Loosen the hose clamp where the rubber intake hose connects to the mass-air sensor.
3) On some vehicles with a manual transmission;you may need to unhook the vacuum pipe from the rubber hose junction.
4) Carefully remove the electrical plug connection from the mass-air sensor.
5) Unclip the airbox lid. Remove […]

[Read more →]

Pre-Installation:
1. Remove all stock intercooler pipes and intercoolers (Refer to Factory Service Manual for removal instructions)
2. Install Front Mount Intercooler. (Refer to FMIC installation section)
3. Unbolt Oil Cooler and move forward at least one inch.
a. Remove upper bracket
b. Bolt lower hole to existing hole where factory intercooler was.
c. Mark hole for upper side bracket hole
d. […]

[Read more →]

Please read the instructions completely prior to installation.
1. Raise front of vehicle and support with jack stands. (Refer to the owner’s manual for proper jack points.) Be sure to block the rear wheels to prevent the vehicle from rolling.
2. Remove wheels.
3. Remove the mounting bolts for the stock caliper, but do not disconnect the brake […]

[Read more →]