Automotive Manual, Car Parts and News

The FP-102 (‘01-Newer Excursion and ’99-Newer F250 - F750) is a no-holes base. Installing a no-holes base does not require drilling any holes into the vehicle. The base mounts under the seat bracket and is compressed to the floor using the seat bolts. Note: For extra stability, the use of a Brace 2 or Brace […]

[Read more →]

FRONT OF VEHICLE – DISASSEMBLY AND ASSEMBLY
1. Park vehicle on level, hard (concrete) surface.
2. Block the rear wheels of the vehicle to prevent vehicle from moving in either direction and set parking brake.
3. Remove the track bar bolt 30 mm (save for later use) on the driver side of the frame mount (Fig.1), and the […]

[Read more →]

The Auxiliary Idle Control Module, also called Auxiliary Powertrain Control Module (APCM), is for use in Light Trucks equipped with 7.3L DIT Diesel engines. Each kit includes an Auxiliary Idle Control module, wiring harness, mounting bracket and hardware, operator’s card, and this instruction booklet.
CHARGE PROTECTION
Charge Protection is used for maintaining battery charge. In Charge Protection […]

[Read more →]

Removal of Stock System:
1. Separate the stock exhaust system at the slip joint by the muffler. Remove the rear exhaust from rubber hangers and remove the system from under the truck.
2. Using a 15mm socket or wrench, remove the two (2) bolts at the turbo flange and remove the stock down pipe.
Installing Your Front Section […]

[Read more →]

To Start the installation:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Unlock the red locking tab on the air temperature sensor electrical connection, then depress the locking lever and pull apart the temperature sensor electrical connection
3. Loosen the hose clamp that secures the intake tube to the throttle body and pull […]

[Read more →]

1) Front brackets are identical and are simply turned 180 degrees out so face of bracket is facing outside of truck.
2) Bars can be mounted either side and are identical.
3) Body mount torque is 65 ft.-lbs.
4) Holes in rocker panel are usually covered with black or grey tape from manufacturer

[Read more →]

These installation instructions describe the steps for direct coupled mounting of the ES142B2… master/slave spring return electronic damper actuators.
Prerequisites
• Check the length of the damper shaft. The minimum length to attach two actuators is 4 inches (100 mm) long.
• Order the tandem mounting bracket ASK73.1
• The actuators are shipped from the factory with 5° preload. […]

[Read more →]

STEP 1. Open up the power outlet door and locate and remove one (1) Phillips head screw using your # 2 Phillips screwdriver . Set screw aside. Open up both the cup holder door and the ashtray door. Remove the dash trim bezel that surrounds the radio and climate control and extends across the instrument […]

[Read more →]

This inlet pipe kit requires the removal and reinstallation of emissions related components. If you are not familiar with the installation and/or the operation of these components then please refer this installation to a qualified professional.
Installing the Short Ram Air Intake System
a) When installing the AEM Air Intake System, DO NOT completely tighten the hose […]

[Read more →]

Installing the Short Ram Air Intake System
a) When installing the Short Ram Air Intake System, DO NOT completely tighten the hose clamps or mounting tab hardware until instructed to do so later in these instructions.
b) Check to see that the inside of the AEM inlet pipe and air filter are clean and free from any […]

[Read more →]