Automotive Manual, Car Parts and News

The FP-102 (‘01-Newer Excursion and ’99-Newer F250 - F750) is a no-holes base. Installing a no-holes base does not require drilling any holes into the vehicle. The base mounts under the seat bracket and is compressed to the floor using the seat bolts. Note: For extra stability, the use of a Brace 2 or Brace […]

[Read more →]

Removing the OEM seat
A. Begin by lifting the bottom cushion out from the rubber grommets in the floor (See fig. 6). Remove the seat belts by removing the OEM nuts from their mounting studs using a 18mm socket/wrench (See fig. 1). Do not remove the shoulder straps anchored at each side of the vehicle.
B. Remove […]

[Read more →]

The mounting procedure outlined below covers 1973 - 1993 Dodge W250 & W350 trucks. You will need to refer to the illustrations and familiarize yourself with each of the undercarriage components and their relative position to each other. Then proceed as follows:
1. Remove the Front Bumper and Front Bumper Mounting Brackets from the Frame Horns. […]

[Read more →]

Removal of Stock System:
1. Separate the stock exhaust system at the slip joint by the muffler. Remove the rear exhaust from rubber hangers and remove the system from under the truck.
2. Using a 15mm socket or wrench, remove the two (2) bolts at the turbo flange and remove the stock down pipe.
Installing Your Front Section […]

[Read more →]

PRE-INSTALLATION NOTES
1. Special literature required: OE Service Manual for model/year of vehicle. Refer to manual for proper disassembly/reassembly procedures of OE and related components.
2. Adhere to recommendations when replacement fasteners, retainers and keepers are called out in the OE manual.
3. Larger rim and tire combinations may increase leverage on suspension, steering, and related components. When […]

[Read more →]

Intercooler Assembly Installation:
1. Disconnect the negative battery cables from both batteries
2. Disconnect the inlet air temperature/ pressure sensor connector located on the air box cover. the connector is shown in Figure 1.
3.Remove the nut that fastens the air filter housing to the radiator cross brace.
4. Loosen the hose clamp that secures the air inlet duct […]

[Read more →]

PROCEDURE
1. Begin installation by working on driver side of the vehicle starting at the front of the inner rocker panel.
2. Located on the inside as well as the bottom inner of the rocker panel you will see one thread hole and one thread stud for each mounting bracket refer to diagram 1. (Note all brackets […]

[Read more →]

Truck Preparation
1. Check part quantities using the Parts List on Page 2.
2. Block vehicle wheels. Some vehicles may require you to raise the rear of the truck in order to make it easier to drill for installing the mounting brackets on the truck frame.
3. You may wish to remove the wheels to give yourself greater […]

[Read more →]

These instructions outline a simple procedure of replacing the main seals and dust boots on the 1982- 83 200sx or 1986-87 Maxima rear brake calipers. Most parts are interchangeable between the two calipers, including the pads, sliders, pistons, hardware, seals, anti-squeal shims, and brake lines. The mounting brackets, and the geometry of the E-brake arms […]

[Read more →]

PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. DO NOT ATTEMPT INSTALLATION ALONE; PERSONAL INJURY OR DAMAGE TO THE TRUCK MAY RESULT.
2. From underside of vehicle, remove the passenger and driver side splash shield and the air valance.
3. Measure and mark 12 ―” from the outside and […]

[Read more →]