Automotive Manual, Car Parts and News

Diesel Turbo Lifesaver (DTLS) is a computer controlled device that allows you to set an automatic engine idle sequence to properly cool your turbocharger before engine shutdown as required by Ford and Navistar. Failure to follow recommended turbo cooling procedures can lead to premature bearing failure that is NOT covered under the factory warranty. Installing […]

[Read more →]

People’s lives depend on your safe installation of our products. It is important to read, understand and follow all instructions shipped with the products. In addition, listed below are some other important safety instructions and precautions you should follow:
• To properly install lighting system, you must have a good understanding of automotive systems, along with […]

[Read more →]

Intercooler Assembly Installation:
1. Disconnect the negative battery cables from both batteries
2. Disconnect the inlet air temperature/ pressure sensor connector located on the air box cover. the connector is shown in Figure 1.
3.Remove the nut that fastens the air filter housing to the radiator cross brace.
4. Loosen the hose clamp that secures the air inlet duct […]

[Read more →]

1. Disconnect the negative battery terminal to prevent an accidental short circuit.
2. If equipped with center speaker: Unclip and remove the grille. Remove (4) Phillips screws securing the speaker. Unplug and remove the speaker. Unclip the panel above the radio including the a/c vents, then unplug hazard switch and remove.
3. Unclip the panel above the […]

[Read more →]

Disconnect the negative battery terminal before starting this installation.
1. Remove the air intake duct, the air intake box and the air vacuum lines connected to the air box. Unbolt the air mass sensor from the air box and set aside at this point. This installation also requires removal of the front bumper and the air […]

[Read more →]

Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set parking brake.
c. If engine has run in the past two hours, let it cool down.
d. Disconnect all negative battery terminals.
e. Jack up front of the vehicle and place on properly rated jack stands.
f. Remove driver’s side fender liner.
g. Do not discard stock components after […]

[Read more →]

KIT FEATURES
• DIN Mount Radio Provision with Pocket
• ISO Mount Radio Provision with Pocket
• Bonus Display Replacement Pocket
• Retains Factory Display For Automatic
Climate Controls
A) Radio Housing • B) ISO Brackets • C) Trim Plate • D) Display Replacement Pocket • E) Display Retention Brackets • F) (2) 3/8” #10 Bolts and (2) #10 Nuts.

[Read more →]

Electronic Climate Control
1. Disconnect the negative battery terminal to prevent an accidental short circuit.
2. Unscrew the shift knob counter clockwise to remove. (Figure A)
3. Unclip and remove the cup holder/parking brake cover and shifter cover as one unit. (Figure B)
4. Remove (2) Phillips screws from the bottom of the radio/climate control panel. (Figure C)
5. Open […]

[Read more →]