Automotive Manual, Car Parts and News

Most 17” wheels will clear the outer diameter of the caliper for a 328mm or 332mm rotor kit. For a 355mm kit, a minimum 18” wheel is typically required, and for a 380mm rotor kit, a minimum 19” wheel is needed. The more critical clearance, however, is the gap between the spokes of the wheel […]

[Read more →]

1. After the front lip spoiler is prepped and painted, double-sided tape should be applied to the indentation on the inside of the front spoiler. This surface has to be CLEAN and DRY for the tape to properly adhere. A residual-free cleaner is recommended (e.g. Wurth ™ Clean-Solve) to prepare the surface. The surface of […]

[Read more →]

Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not completely unroll and lay flat. This is normal and only temporary. Just place the liner on the floor or in the back of your vehicle with a weight in each corner (a book works well). After […]

[Read more →]

1. Disconnect the negative battery terminal to prevent an accidental short circuit.
2. If equipped with center speaker: Unclip and remove the grille. Remove (4) Phillips screws securing the speaker. Unplug and remove the speaker. Unclip the panel above the radio including the a/c vents, then unplug hazard switch and remove.
3. Unclip the panel above the […]

[Read more →]

STEP 1. Set emergency brake. Place gear selector away from dash. Open ashtray, depress push lever, and remove ashtray. Remove small trim insert located between flasher and defrost button by hooking small indent in the trim piece with hook tool and pulling out , set aside. Using Phillips screwdriver, locate and remove Phillips screw located […]

[Read more →]

The Uprev Cipher and Osiris software/cable requires the factory CAN wiring to be extended to the OBDII port under the dash of 04-06 Nissan Sentras in order for them to properly interface with the Factory ECU. To do this, you must first locate the CAN HI and Can LO wires coming from the ECU into […]

[Read more →]

The Nissan Enhanced OBD II software is included with the Dyno-Scan™ for Windows software. A unique Nissan Enhanced Product Key is purchased to unlock the features. The enhanced upgrade works on 2000 and newer Nissan and Infiniti vehicles1. The enhanced software allows you to:
Read enhanced diagnostic trouble codes (DTCs) from systems like ABS and airbag
Display […]

[Read more →]

PROCEDURE
1. Begin installation by working on driver side of the vehicle starting at the front of the inner rocker panel.
2. Located on the inside as well as the bottom inner of the rocker panel you will see one thread hole and one thread stud for each mounting bracket refer to diagram 1. (Note all brackets […]

[Read more →]

Study these instructions completely before proceeding. Engine and/or turbocharger damage may occur if any component within these instructions is improperly installed. Turbonetics, Inc or any of its distributors cannot be held responsible for damages as a result of negligent or improper installation. This complete turbocharger system can be installed using common tools and automotive procedures, […]

[Read more →]

Complete Stock passenger side intake. Please disconnect battery terminals before installation.
With 10mm socket or wrench, loosen the 2 bolts holding in lower engine cover and remove.
Disconnect MAF sensor harness. With 10mm socket or wrench loosen bolt holding in air box.
Loosen clamps on intake using 5/16” nut driver.
With pliers pull back crank case line from intake.
Remove […]

[Read more →]