Automotive Manual, Car Parts and News

1. Layout all parts and check quantities against the Bill of Materials. Completely read instructions before beginning installation.
2. Jack the front of the vehicle in accordance to manufacturer recommendation and support with jack stands, so that the front two tires are off the ground
3. Remove the front tires/wheels.
4. Disconnect the steering linkage and push forward, […]

[Read more →]

Read instructions before assembling. Fasteners should be finger tight until instructed to tighten according to the torque chart. Use standard methods and practices when attaching snowplow including proper personal protective safety equipment.
MOUNT INSTALLATION
1. If the vehicle is equipped with a stamped-steel splash guard and/or tow hooks, remove them. Retain the splash guard, tow hooks, and […]

[Read more →]

Read all instructions before starting any work.
1. Remove the old exhaust system from the truck. Use WD-40, or a similar lubricant, to aid in removing the rod hangers from the rubber isolators.
2. Install DynoMax front RH y-pipe 53313 with gasket 31540. Insert the rod hanger into the rubber isolator. Finger tighten the fasteners at this […]

[Read more →]

Your Airaid Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS […]

[Read more →]

Step 1: Position truck on a flat surface and lift the front wheels off the ground using jack stands or a (2) two post lift if available. Remove the wheels and tires on both sides. Remove the two lower sway bar nuts on both sides of truck. (Insert A) Remove the driver’s side cotter pin […]

[Read more →]

PROCEDURE
1. Begin installation by working on driver side of the vehicle starting at the front of the inner rocker panel.
2. Located on the inside as well as the bottom inner of the rocker panel you will see one thread hole and one thread stud for each mounting bracket refer to diagram 1. (Note all brackets […]

[Read more →]

This guide is designed to help you select and properly install a child safety seat compatible with your 2004-2009 Nissan Titan King Cab. To compile this list, our safety engineers fitted numerous Child Restraint Systems (CRS), including infant restraints, forward-facing child seats, booster seats and their combinations. If properly installed, the CRS noted below have […]

[Read more →]

This kit is used for 2004-2005 Nissan Titan 3 and should only be installed on a vehicle that is in good working condition. Before you install the kit, thoroughly inspect the vehicle for corrosion or deformation of the sheet metal around the factory body mounts. If the vehicle is suspected to have been in a […]

[Read more →]

The recommended push beam height for this undercarriage assembly is 10-1/2″ from the center of the push beam to level ground. DO NOT exceed 12-1/2″ in height for this undercarriage.
WARNING: Always perform vehicle undercarriage installations with the keys removed from the vehicle’s ignition. Properly tag the ignition switch to alert others work is being performed […]

[Read more →]

Power Step - Installation Instructions
1. Drill Holes for Arms
Locate the Drill Template in the parts kit. Place it along the sill under the vehicle. Slide the upper front hole in the template over the stud in the sill and install an 8mm Nut over the stud. Then install a Medium Socket Head Bolt in the […]

[Read more →]