Automotive Manual, Car Parts and News

MOUNTING LOCATION: The enclosure mounts behind the seat of a regular cab truck.
INSTALLATION: Follow the steps below
1. Move seat and seat back all the way forward. You do not need to remove the seat.
2. If truck is equipped with a rear tool tray, this tray must be removed to mount enclosure. Remove rubber caps to […]

[Read more →]

The following information describes the installation procedure for the M-11572-GT “ENGINE START” push-button
into a 2005-‘09 Mustang.
STEP 1: Start by removing the (2) screws found at the rear of the center console underneath the armrest.
STEP 2: Remove the trim plate which surrounds the Shifter Handle (Auto) or Shifter Boot (Manual).
Note: Manual transmission applications will require removing […]

[Read more →]

- Complete Stock Intake.
- With 5/16” nut driver loosen clamps on OE tube at turbo/air box and remove. Loosen clamp at turbo and disconnect crank case line with pliers. Remove tube.
- Disconnect air temp & MAF sensor. Loosen 10mm nut holding in front of air box using wrench or socket. Lift up and pull OE […]

[Read more →]

Dodge Caliber, Jeep Compass Subwoofer Installation
1. Lift up on the B pillar post cover and then pull it towards the center of the car to remove.
2. Using a panel removal tool gently pry up the threshold/kick panel along the bottom of the front and rear door openings to release fasteners and remove panel.
3. Find the […]

[Read more →]

Complete Stock passenger side intake. Please disconnect battery terminals before installation.
With 10mm socket or wrench, loosen the 2 bolts holding in lower engine cover and remove.
Disconnect MAF sensor harness. With 10mm socket or wrench loosen bolt holding in air box.
Loosen clamps on intake using 5/16” nut driver.
With pliers pull back crank case line from intake.
Remove […]

[Read more →]

1. Cold air shown. Kit can also be short ram.
2. Complete Stock intake. Please disconnect battery terminals before installation.
3. Disconnect MAF sensor harness. Unclip upper half of air box. Loosen clamps using 10mm socket or wrench.
4. Remove crank case line.
5. Remove stock intake tube and upper air box.
6. With 10mm socket or wrench loosen bolt […]

[Read more →]

1. Complete Stock intake. Please disconnect battery terminals before installation.
2. Remove plastic battery ram air.
3. Disconnect Crank case line and remove plastic fitting. Save for later install (See step 11).
4. With 10mm wrench loosen loosen VSV valve on air box, disconnect and remove. Save for later install (See step 11).
5. With 10mm socket or wrench […]

[Read more →]