Automotive Manual, Car Parts and News

The contents of these kits have been specifically designed for the original equipment AODE/4R70W STAMPED STEEL (GROB) direct clutch drum. This stamped steel style drum is also used as a replacement part when ordering a NEW drum for AOD (non-electronic) transmissions since the cast iron drums for 1980 through 1990 AOD’s are no longer being […]

[Read more →]

Read all instructions before starting any work.
1. It is suggested to lower or completely remove the spare tire from under the vehicle. This will help in the removal of the original equipment (OE) exhaust system and with the installation of the DynoMax exhaust kit.
2. Remove the existing exhaust system assembly from the vehicle. Lubricate the […]

[Read more →]

Step Description
1. Place the vehicle on a hoist that leaves the entire underside of the frame.
2. Drain all the fuel from the original equipment tank using a pump or siphon. In some cases Dodge tanks have a screen at the tank inlet which won’t allow a siphon hose to enter. In this case, it may […]

[Read more →]

Proper installation of this kit requires knowledge of the factory recommended procedures for removal and installation of original equipment components. We recommend that the factory shop manual and any special tools needed to service your vehicle be on hand during the installation. Installation of this kit without proper knowledge of the factory recommended procedures may […]

[Read more →]

Before removing the original equipment oxygen sensor (hereinafter OE Sensor) from your vehicle, make note of the location of the connectors joining the oxygen sensor and vehicle wiring. The vehicle manufacturer has deemed this to be a suitable environment for a connection and it is recommended that the universal connector be installed close to the […]

[Read more →]

Follow carefully the instructions listed on these pages and use the template provided, do not over tighten bolts. Do not use silicone on any connections. Use urethane Ensure that safe work practices are followed when installing your Airflow Snorkel. Protective ear and eye wear should be worn at all times when using power tools.

[Read more →]