Have tried using a g-clamp, but it will only move 2-3mm, had no trouble with the front brakes.
Ans: Push in while turning the piston clockwise there are tools that put pressure on the piston while turning notice the two spots on the caliper piston face there the tool pins catch turn and push inward. Your [...]
How to push the rear disc brake piston on a Nissan Pintara to get the new pads in?
December 21st, 2010 · No Comments
1991 Jaguar XJ-S Parking Brake Disc Pads Installation
May 20th, 2010 · No Comments
This manual contain the installation of parking brake disc pads for jaguar xj-s 1991 vehicles.
Removal & Installation (XJS)
Remove parking brake caliper. See PARKING BRAKE CALIPER R & I under REMOVAL & INSTALLATION. Remove pad-to-carrier mount nut. Note pad position and remove disc pads. See Fig. 4 . To install, reverse removal procedure. Repeatedly operate handbrake [...]
Mazda Genuine Rear Disc Pad Installation and User’s Instructions
October 28th, 2009 · No Comments
REAR DISC PAD INSTALLATION
1. Remove the parking brake cable.
2. Remove the bolt.
3. Slide the caliper to the position shown in the figure.
4. Remove the disc pads from the mounting support.
5. Remove the (shims and guide plates) . Store the removed parts away from dirt, as they will be reused.
6. Clean the exposed area of the [...]
Rear Drum Brake (4WD and Pre Runner) Removal
October 9th, 2009 · No Comments
1. INSPECT SHOE LINING THICKNESS
Remove the inspection hole plug, and check the shoe lining thickness through the hole. If less than the minimum, replace the shoes. Minimum thickness: 1.0 mm (0.039 in.)
2. REMOVE REAR WHEEL
3. RELEASE PARKING BRAKE LEVER
4. REMOVE BRAKE DRUM
HINT:
If the brake drum cannot be removed easily, do the following steps.
(a) Remove the [...]