STEP 1. Open up the power outlet door and locate and remove one (1) Phillips head screw using your # 2 Phillips screwdriver . Set screw aside. Open up both the cup holder door and the ashtray door. Remove the dash trim bezel that surrounds the radio and climate control and extends across the instrument […]
1998 Dodge Ram Pickup Pro.Fit Kit Installation Instructions
November 27th, 2009 · No Comments
2002-Up Dodge RAM Telescopic Trailer Tow Mirror Installation Instructions
November 27th, 2009 · No Comments
Schefenacker recommends that this installation be carried out by a professional installer. Please read ALL the instructions and warnings thoroughly before installing theTelescopic Trailer Tow Mirrors.These mirrors are designed only for the vehicles listed on this page. Ensure that the fitting instructions are followed exactly, as failure to do so may result in incorrect installation, […]
Crooked Willow Composites (CWC) Racing Dual Oil Cooler Kit Installation Instructions
November 8th, 2009 · No Comments
1. Flip up headlights (use dash switch, not column lever)
2. Disconnect and remove battery, battery box (2X 10mm hex), and battery shelf (3X 10mm hex)
3. Remove covers (black) from around the headlights (phillips head screwdriver)
4. Remove intake duct and air box (OEM)
5. Remove intercooler (move AST to the side, no need to disconnect)
6. Remove intercooler […]
2004-2005 Mazda RX-8 Grille Install Instructions
October 28th, 2009 · No Comments
Tools Reqd: ratchet with 8mm and 10mm sockets (extension not required), small flat blade screwdriver, small phillips head screwdriver.
Open the hood and prop it up.
Remove the four 10mm bolts (see photo)
Remove the quick-lock fasteners holding the weather trim piece in place. They are removed using a small Phillips screwdriver.
Remove the 4 quick-lock fasteners in the […]
Mazda 3 Smoked Rear Reflector with LEDs Installation Instructions
October 21st, 2009 · No Comments
This installation guide specifically focuses on the hatchback version of the vehicle. Installation on the sedan will be similar.
Tools required:
• Socket wrench with 10mm socket and 8-inch extension
• Philips-head screwdriver
• Flat-head screwdriver
• Supplies for tapping into four (4) to eight (8) 22mm wires (depending on desired operation)
2009 Toyota Corolla TWM Performance Short Shifter Installation Instructions
October 16th, 2009 · No Comments
It is preferable to park on a flat surface, as you will have to engage and disengage the hand brake and shift from gears to neutral. If you cannot do so and are obliged to install the short shifter on a slightly inclined surface, place wooden blocks in front and behind the wheels to prevent […]
2006-2008 MX-5 / Miata Sound systems CWC-9 and CWC-9B Installation Manual
September 23rd, 2009 · No Comments
Below are some of the features associated with this speaker component set:
• This system was specifically designed for the Miata/MX5.
• Hundreds of hours have gone into the testing and design of this audio system.
• Measurements were made with the industry’s top equipment.
• No other speakers in the world have been so meticulously designed specifically for […]
Argos BlueStar - GM Onstar replacement Bluetooth adaptor Installation and Users Guide
August 19th, 2009 · No Comments
Thank you for purchasing our “Argos™” series Bluetooth® wireless technology mobile telephone interface. This interface is designed to provide integration of your OnStar equipped vehicle’s built in mobile phone capabilities and your Bluetooth® enabled mobile phone. This document is designed to be a supplemental guide to installation and is not a substitute for proficient knowledge […]