This installation guide is intended to be used as a supplement to the BMW Installation Instructions for X5 DVD Video System II. The kit comes with the audio/video cables but I chose the Streetwires Zero Noise-Series cables to prevent any interferences or noises from entering into the system. The part numbers and prices for the [...]
May 31st, 2011 · No Comments
March 19th, 2011 · No Comments
First, unscrew the 7 screws holding on the door panel. Next you carefully pry off the tweeter cover that is where the mirror is. Lift the panel up and off of the door. Undo all of the wiring connections except for the window controller. Open the 2 black rubber view ports (Circled in Yellow) and [...]
January 31st, 2011 · No Comments
Instructions for Bravada, Rainier and Blazer start here. See below for other instructions
STEP #1: Partially pull off the bezel that surrounds the vents, radio, climate control, and power outlets (Bravada only). Start from the top of the bezel with the hook tool, and working your way to the bottom releasing a total of (6) clips. [...]
December 31st, 2010 · No Comments
Not the light next to the headlight, but rather that light positioned under the headlight on the bumper of the vehicle. I attempted to go into the vehicle through the wheel well, but hit a dead end. Does the bumper need to come off?
December 16th, 2010 · No Comments
The radio is secured to the entire radio-pocket assembly as one unit, including the plastic panel surrounding the radio. DO NOT pull the plastic panel away from the radio or you will break the plastic panel. The radio and plastic panel must be removed together, as one unit.
November 22nd, 2010 · No Comments
READ INSTRUCTIONS COMPLETELY BEFORE INSTALLING THIS BRACKETRON PHONE MOUNT. All instructions are written from the drivers seat position looking forward at the vehicle dash. We advise caution whenever your removing or handling plastic parts of a vehicles dash. WARNING: Unnecessary force or pressure can cause pieces to crack or break. Logo and part number will [...]
November 10th, 2010 · No Comments
Attachment Tabs: Motorhome mount tow bars are recommended for use with this baseplate. Due to the design of the removable tabs, the RangeFinderII and Ambassador tow bars can not be used. The Acclaim tow bar may be used, but will not fold and store on the front of the vehicle. Adapters, except the BX8833 and [...]
May 31st, 2010 · No Comments
REMOVAL & INSTALLATION Front Turn Signal and Parking Lights CRV MODELS AND V6 ODYSSEY MODELS
1. Turn the steering wheel in the opposite direction from which the bulb is to be removed.
2. Using a flat blade screwdriver, remove the fasteners securing the inner fender behind the headlight and pull back on the
inner fender liner.
3. Remove the [...]
January 10th, 2010 · No Comments
Removing the OEM seat
A. Begin by lifting the bottom cushion out from the rubber grommets in the floor (See fig. 6). Remove the seat belts by removing the OEM nuts from their mounting studs using a 18mm socket/wrench (See fig. 1). Do not remove the shoulder straps anchored at each side of the vehicle.
B. Remove [...]
November 24th, 2009 · No Comments
If you are not familiar with the use of hand tools or not accustomed to working on motor vehicles, have a dealer or accessory shop install the X2000 Platinum Series EZ-Lift Lid. Carefully read all the instructions prior to attempting to fit the Lid. Before fitting the Lid, park the vehicle on level ground in [...]