Automotive Manual, Car Parts and News

TOOLS REQUIRED: #2 Phillips screwdriver, hook tool, 9/32” & 5/16” sockets & driver, telescopic magnet, 5/64” drill bit and drill, protective cloth, marking pen.
PARTS INCLUDED: Pro.Fit VSMTM , instructions, two (2) # 10x 5/8” screws.
LOCATION: To the right of the radio
STEP 1. Begin by removing the simulated wood grain bezel that surrounds the ashtray. Insert […]

[Read more →]

Step 1. Driver and Passenger Bottoms/DB&PB: The parts of the seat cover are labeled inside. Use the “Seat Cover Piece Identification Chart” to identify the parts. Temporarily remove the screw from the recline lever using a Phillips screwdriver.
Step 2. Driver and Passenger Bottoms/DB&PB: Slide the seat cover over the upholstered flap on the outside, then […]

[Read more →]

STEP 1. Open up the power outlet door and locate and remove one (1) Phillips head screw using your # 2 Phillips screwdriver . Set screw aside. Open up both the cup holder door and the ashtray door. Remove the dash trim bezel that surrounds the radio and climate control and extends across the instrument […]

[Read more →]

All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.
TOOLS REQUIRED: Small flat screw driver, #2 Phillips screwdriver, hook tool, 5/64” drill bit, and drill, marking pen
STEP 1.
Begin by opening […]

[Read more →]

INSTALLATION OF HOTCHKIS FRONT SWAY BAR
1) Drive the front of the vehicle onto floor ramps and securely block the rear wheels of the vehicle. If ramps are not available, use a jack to lift up the front of the vehicle and use jack stands to support it. Do not remove the front wheels during installation […]

[Read more →]