Automotive Manual, Car Parts and News

Installation instructions for the Mitsubishi Montero
- Locate and remove two vertical Phillips screws above the display panel. With Dash Trim Tool (#SIT-104), locate and release six (6) clips that secure the trim bezel. Remove bezel and disconnect emergency flasher wiring harness from the back of the bezel. Set bezel aside carefully.
- Locate and remove the […]

[Read more →]

STEP 1. Begin by opening the armrest door. Using the Phillips screw-driver, locate and remove two (2) Phillips screws inside and toward the back of the armrest storage compartment. Set screws aside. Just in front of the armrest locate a small plastic cap. Using the small flat screw-driver carefully pry cap loose exposing two (2) […]

[Read more →]

1. Disconnect the negative battery terminal to prevent an accidental short circuit.
2. If equipped with center speaker: Unclip and remove the grille. Remove (4) Phillips screws securing the speaker. Unplug and remove the speaker. Unclip the panel above the radio including the a/c vents, then unplug hazard switch and remove.
3. Unclip the panel above the […]

[Read more →]

The front fascia and tie down brackets are removed for baseplate installation. Tie down brackets will not be reinstalled. No drilling necessary. The BX8869 is available for the vehicle. Attachment Tabs are 22 inches center to center and a height of 15 5/8 inches.
1. Remove two phillips screws from under fascia corner, just forward of […]

[Read more →]

STEP 1. Begin by removing the air vent assembly above the climate control module. There are three (3) clips on the top and four (4) clips on the bottom of the vent. (See photo # 3.) Slide your hook tool between the vent assembly and dash. Push the clip towards the vent to release it, […]

[Read more →]

To original Nissan radio is mounted to a center dash assembly which contains not only the radio but air conditioner controls, and two pockets below the radio. When replacing the radio, this entire assembly must be removed first, then the Nissan radio can be unscrewed and removed and a new replacement radio can be installed.

[Read more →]

All instructions are written from the drivers seat position looking forward at the vehicle dash. We advise caution whenever your
removing or handling plastic parts of a vehicles dash.
Step. 1
Start by applying the parking brake and placing the transmission into the neutral position.
- For automatic transmissions, grasp the plastic cover below the shift knob and push […]

[Read more →]

STEP 1. Begin by inserting hook tool at very back of trim panel surrounding gear shift selector. Release two (2) clips at the rear and continue towards front of panel to release two (2) more clips. CAUTION! These parts are plastic and this panel comes out extremely hard.
STEP 2. Remove ashtray by removing screw on […]

[Read more →]

Preparation
1. Cover the front seats, floorboards, dash and steering wheel with a clean drop cloth or disposable plastic covers.
Note: Always wear eye and hand protection when working with glass. Make sure you have the right glass and moldings and the urethane systems are current. Windshield part numbers are FW2464 and FW2461.
2. Drape the fender with […]

[Read more →]

1. Pull vehicle into service bay and access center console.
2. Disconnect both battery terminals. These cables must be disconnected during installation to insure proper initialization of the DICE module when it is connected.
3. Twist the shift knob off by rotating it counter-clockwise. Remove the trim plate covering the Gear Selector which is held in place […]

[Read more →]