Automotive Manual, Car Parts and News

Pillar installation Directions: Read directions before starting installation Model# (17212 Dual), (17213 Triple) Fits 03+ Dodge Ram
1)  Remove Stock Pillar by removing the two  screws located under the caps of pillar handle.
2)  Install Gauges in new pillar.
3)  Tape or secure gauge wiring to back of pillar.
4)  Install new pillar in place of old pillar.
5)  Use provided screw to hold pillar in place:
•  Make sure screw is aligned with factory hole to avoid cross threading
•  Don’t over tighten screw.

[Read more →]

Dodge Caliber, Jeep Compass Subwoofer Installation
1. Lift up on the B pillar post cover and then pull it towards the center of the car to remove.
2. Using a panel removal tool gently pry up the threshold/kick panel along the bottom of the front and rear door openings to release fasteners and remove panel.
3. Find the […]

[Read more →]

1) Disconnect the battery.
2) Open door completely and loosen the door catch that is attached to the inner frame and the door. Later we’ll remove it.
3) Remove fender:
Remove all 6 screws that are attached to the inner fender well.
Remove (2) 10mm bolts that secure the bumper to the fender.
After removing the (2) 10mm bolts you […]

[Read more →]

INSTALL GAUGE COMPONENTS BY USING INSTRUCTIONS THAT WERE SUPPLIED WITH THE GAUGE.
1. Begin by removing the A pillar trim by locating upper seam and prying outward. (Do not use tool to pry) With A pillar pulled out, lift upwards and remove completely.
2. With your stock A pillar now removed you will need to drill a […]

[Read more →]