Automotive Manual, Car Parts and News

TOOLS REQUIRED: #2 Phillips screwdriver, hook tool, 9/32” & 5/16” sockets & driver, telescopic magnet, 5/64” drill bit and drill, protective cloth, marking pen.
PARTS INCLUDED: Pro.Fit VSMTM , instructions, two (2) # 10x 5/8” screws.
LOCATION: To the right of the radio
STEP 1. Begin by removing the simulated wood grain bezel that surrounds the ashtray. Insert […]

[Read more →]

PLEASE READ COMPLETE INSTRUCTIONS BEFORE INSTALLING THIS Pro.Fit MOUNT. All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break
STEP 1.
Begin by removing trim bezel that surrounds climate control. Insert hook […]

[Read more →]

STEP 1. Begin by opening the armrest door. Using the Phillips screw-driver, locate and remove two (2) Phillips screws inside and toward the back of the armrest storage compartment. Set screws aside. Just in front of the armrest locate a small plastic cap. Using the small flat screw-driver carefully pry cap loose exposing two (2) […]

[Read more →]

STEP 1. Open up the power outlet door and locate and remove one (1) Phillips head screw using your # 2 Phillips screwdriver . Set screw aside. Open up both the cup holder door and the ashtray door. Remove the dash trim bezel that surrounds the radio and climate control and extends across the instrument […]

[Read more →]

STEP 1. Set emergency brake. Place gear selector away from dash. Open ashtray, depress push lever, and remove ashtray. Remove small trim insert located between flasher and defrost button by hooking small indent in the trim piece with hook tool and pulling out , set aside. Using Phillips screwdriver, locate and remove Phillips screw located […]

[Read more →]

STEP 1. Begin by removing the air vent assembly above the climate control module. There are three (3) clips on the top and four (4) clips on the bottom of the vent. (See photo # 3.) Slide your hook tool between the vent assembly and dash. Push the clip towards the vent to release it, […]

[Read more →]

STEP 1. Begin by inserting hook tool at very back of trim panel surrounding gear shift selector. Release two (2) clips at the rear and continue towards front of panel to release two (2) more clips. CAUTION! These parts are plastic and this panel comes out extremely hard.
STEP 2. Remove ashtray by removing screw on […]

[Read more →]

All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.
TOOLS REQUIRED: Small flat screw driver, #2 Phillips screwdriver, hook tool, 5/64” drill bit, and drill, marking pen
STEP 1.
Begin by opening […]

[Read more →]

STEP 1. Set the emergency brake. Insert key into shift lock mechanism. With vehicle ignition off, put vehicle into gear. Remove ash tray by pressing on its face. It will pop open. Push down on lip located on top of ash tray. Ash tray will rotate out. Set aside. Next, remove the trim panel surrounding […]

[Read more →]

All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.
STEP 1.
Insert the two (2) radio removal tools into the slots on the face of the radio. NOTE: Make sure the […]

[Read more →]