Automotive Manual, Car Parts and News

As you read through this procedure, note that each part referenced has the same callout number throughout. Also, the part number in the text matches the corre- sponding part number in the art. Kit parts are prefaced by the word kit in italics.
NOTE
You will find it easier to keep track of hardware if immediately after […]

[Read more →]

Thank you for purchasing Figure’s 2005-Present Dodge Charger Grille set. These grilles are fabricated employing quality materials and finishes, and have been engineered to enhance the look of your vehicle for the duration of its life. Proper installation is essential to your overall satisfaction, so please read these instructions before attempting to install the grilles. […]

[Read more →]

- Complete Stock Intake.
- With 5/16” nut driver loosen clamps on OE tube at turbo/air box and remove. Loosen clamp at turbo and disconnect crank case line with pliers. Remove tube.
- Disconnect air temp & MAF sensor. Loosen 10mm nut holding in front of air box using wrench or socket. Lift up and pull OE […]

[Read more →]

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the air temp. sensor electrical connection.
3. Loosen the hose clamps at the turbo inlet and the airbox outlet as shown.
4. Remove the intake tube from the vehicle as shown.
5. Loosen and remove the 10mm nut that retains the airbox to the […]

[Read more →]

Get ready to install the kit.
1. Remove the shift transfer case shift linkage.
a. If present on your vehicle, remove four bolts and skid plate from the frame under the transmission and transfer case.
b. Remove two rubber bushings and transfer case shift linkage from shift lever and transfer case.
2. Remove the front bumper.
a. Remove nine panel […]

[Read more →]

Installing the Short Ram Air Intake System
a) When installing the Short Ram Air Intake System, DO NOT completely tighten the hose clamps or mounting tab hardware until instructed to do so later in these instructions.
b) Check to see that the inside of the AEM inlet pipe and air filter are clean and free from any […]

[Read more →]

Complete Stock passenger side intake. Please disconnect battery terminals before installation.
With 10mm socket or wrench, loosen the 2 bolts holding in lower engine cover and remove.
Disconnect MAF sensor harness. With 10mm socket or wrench loosen bolt holding in air box.
Loosen clamps on intake using 5/16” nut driver.
With pliers pull back crank case line from intake.
Remove […]

[Read more →]

If for any reason the vehicle’s cooling system needs to be filled with coolant due to a service repair or maintenance, use the Coolant Refill Tool #J-45695.
• Using this tool properly will ensure complete filling without trapped air bubbles in the cooling system.
• Air pockets in the cooling system can cause:
A) Overheating
B) Poor heater performance
C) […]

[Read more →]

Step 1: Note these instructions are for both the upper and the lower, so not all steps are applicable of you bought only an upper or a lower grille. The lower will be covered first.
Step 2: Get your tools out, a flat head screwdriver (small), wire cutters, and possibly some pliers or channel locks. Then […]

[Read more →]

Most modern vehicles have an in-line connector in the wiring loom between the ignition switch and the under dash wiring looms. In some cases this connector is on the back of the switch itself. Locate this connector, seperate plug and socket and interpose the turbo timer connectors between them. Connect the black lead from the […]

[Read more →]