Automotive Manual, Car Parts and News

New Ford vehicles have a new electronic sensor installed in the transmission and the speedometer cable clips into the back of the electronic sensor. (See cable drive unit) our adapter kit and transmission sensor is installed on the transmission side of the electronic sensor. Do not remove the speedometer cable fromthe back of the electronic [...]

[Read more →]

1. Turn off the ignition and disconnect the negative battery cable.
2. Disconnect mass air sensor electrical connection.
3. Rotate crank case vent hose locking ring and pull crank case vent hose off of air filter housing. Un-hook wiring harness retaining clip from air box.
3a. Disconnect the brake booster vent line from the air filter housing as [...]

[Read more →]

All instructions are written from the drivers seat position looking forward at the vehicle dash. We advise caution whenever your
removing or handling plastic parts of a vehicles dash.
Step. 1
Start by applying the parking brake and placing the transmission into the neutral position.
- For automatic transmissions, grasp the plastic cover below the shift knob and push [...]

[Read more →]

Read and understand these instructions BEFORE attempting to install this product. Failure to follow installation instructions and not using the provided hardware may damage the intake tube, throttle body and engine.
Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set parking brake.
c. If engine has run in the past two hours, let it cool [...]

[Read more →]

Removing the stock air inlet system
a) Before removing any of the O.E. components, label each individual part so that no components become mixed up during the installation process.
b) Unclip the hard plastic breather hose from the breather nipple by squeezing the blue retaining clip. Slide the purge solenoid valve (PSV) toward the back of the [...]

[Read more →]