Automotive Manual, Car Parts and News

FLARE INSTALLATION PROCEDURES
Step 1: Painting (Optional)
(A) It is recommended that painting be done prior to installation.
(B) Sand (optional) before application of paint.
(C) Clean outer surface with a high-grade degreaser. DO NOT USE
LACQUER THINNER OR ENAMEL REDUCER AS A DEGREASER. Wipe outer surface thoroughly with a tack rag prior to painting.
(D) Paint flares using a high […]

[Read more →]

1) Front brackets are identical and are simply turned 180 degrees out so face of bracket is facing outside of truck.
2) Bars can be mounted either side and are identical.
3) Body mount torque is 65 ft.-lbs.
4) Holes in rocker panel are usually covered with black or grey tape from manufacturer

[Read more →]

PROCEDURE
1. Begin installation by working on driver side of the vehicle starting at the front of the inner rocker panel.
2. Located on the inside as well as the bottom inner of the rocker panel you will see one thread hole and one thread stud for each mounting bracket refer to diagram 1. (Note all brackets […]

[Read more →]

BMW 3 Series (with side jack lifting holes) Clamping Setup
1. Remove conventional clamp jaws.
2. Attach BMW clamping adapter (518315), 1/4 inch spacer (532196) and outer pin support (518313) to pinchweld clamps as shown.
3, Remove plugs in bottom of rocker panels and jacking holes.
4. Lower vehicle onto supports while guiding outer support pins (618302) into jacking […]

[Read more →]