Automotive Manual, Car Parts and News

Removal of original system
1.) start under the hood. locate the turbo. remove the v-clamp from the turbo outlet. loosen the bolt enough to unlatch the t-bolt, then pry the clamp away from the flange at three spots using a flathead screwdriver.
2.) from underneath your vehicle, cut the stock system in two places. first, cut the […]

[Read more →]

1. Disconnect the negative battery cable, and remove the factory “accordion” style intake hose by loosening the two factory clamps.
2. Loosen the two 10mm bolts securing the factory air box to the intake manifold.
3. Disconnect the air temperature sensor wire on the front of the factory air box & twist to remove the sensor from […]

[Read more →]

Dodge Nitro Subwoofer Installation
1. Find the fuse block under the hood and open the fuse box cover.
2. Using a 13mm socket and ratchet loosen and remove the fuse box power supply nut. Fig. 1
3. Connect the ring terminal of the power harness to the fuse box power lug and retighten the nut.
4. Route the wire […]

[Read more →]

Removing the stock air inlet system:
a) Loosen the five screws securing the stock air box lid. Remove the air box lid from the vehicle.
b) Remove the Inlet Air Temperature (IAT) sensor. The metal band will need to be pried off with a flat-head screwdriver. Use care to avoid damaging the IAT sensor.
c) Remove the air […]

[Read more →]

Dodge Caliber, Jeep Compass Subwoofer Installation
1. Lift up on the B pillar post cover and then pull it towards the center of the car to remove.
2. Using a panel removal tool gently pry up the threshold/kick panel along the bottom of the front and rear door openings to release fasteners and remove panel.
3. Find the […]

[Read more →]

Removing the stock air inlet system
a) Before removing any of the O.E. components, label each individual part so that no components become mixed up during the installation process. There is a Ventilation Hose, an Intake Air Temp. Sensor, Purge Solenoid Valve, and a Mass Air Flow Sensor (MAF). Refer to the following diagrams for the […]

[Read more →]

- Remove the clamp (1) securing the crossover tube to the AFM
- Remove the clamp (2) securing the air snorkel to the air box.
- Unplug the AFM connector (3) by pushing down on the tab and pulling away. Do not pull on the wires.
- Remove the two 12 mm bolts (4 & 5) securing the […]

[Read more →]