Automotive Manual, Car Parts and News

Pillar installation Directions: Read directions before starting installation Model# (17212 Dual), (17213 Triple) Fits 03+ Dodge Ram
1)  Remove Stock Pillar by removing the two  screws located under the caps of pillar handle.
2)  Install Gauges in new pillar.
3)  Tape or secure gauge wiring to back of pillar.
4)  Install new pillar in place of old pillar.
5)  Use provided screw to hold pillar in place:
•  Make sure screw is aligned with factory hole to avoid cross threading
•  Don’t over tighten screw.

[Read more →]

We recommend installation be done by a trained professional.
• Read instructions carefully before attempting installation.
• Secure and properly block vehicle prior to installation.
Note: Carli Suspensions’ Heavy Duty Upper Ball Joints need to be disassembled prior to installation. The following steps will be the installation of the ball joint cup only.

[Read more →]

Step 1. Driver and Passenger Bottoms/DB&PB: The parts of the seat cover are labeled inside. Use the “Seat Cover Piece Identification Chart” to identify the parts. Temporarily remove the screw from the recline lever using a Phillips screwdriver.
Step 2. Driver and Passenger Bottoms/DB&PB: Slide the seat cover over the upholstered flap on the outside, then […]

[Read more →]

Loosen the clip securing the Remove the air box mounting screw air box to the throttle body underneath the air box.
Unclip and remove the breather pipe from the cam cover
Remove the two nuts and two screws from the metal shield attached to the front panel. Remove the sheild.
Fit the rubber breather hose approximately 2cm into […]

[Read more →]

Getting started
- Chock the other 3 wheels on both sides
- Release handbrake
- Put the gearbox into neutral
- Loosen wheel nuts
- Jack up the car
- Remove wheel nuts + wheel
- Place jack-stand under car for safety

[Read more →]

LIGHT BAR CUTTING INSTRUCTIONS
1. Two people will be needed to complete this task.
2. Place ONLY THE MOUNTING END CASTING into the rain-gutters of your vehicle.
3. Level each Mounting End Casting so that the top flat area is parallel to the horizon.
4. Take a tape measure and measure the distance between each open end of each […]

[Read more →]

Installing Hardware
1. Open lift gate.
2. Locate the two mounting location as indicated by the arrows.
3. On driver’s side, position drilling template, align the edges and tape in place.
4. Using a punch, mark the location for drilling. Remove paper template, ensure the hole is punched through, flip over paper template and repeat on passenger side.
Note: Use […]

[Read more →]

Ford Explorer/Mercury Mountaineer door panel removal:
1. Open door and lower window. Remove two screws at bottom of panel.
2. Remove plastic trim by pulling from the front end.
3. Dislodge window control panel by pulling up as shown.
4. Remove screw located behind trim piece and disconnect all window control plugs. Pass window control wiring panel through opening […]

[Read more →]

This is the outline of my installation of a Tekonsha Prodigy brake controller into a 2001 3.0 5sp X5.
I opted to install the Prodigy in the console ashtray. It’s in front of the shifter and relatively easy to reach the manual brake lever – it’s just a little tough to reach in 1st and 3rd […]

[Read more →]

1. Complete Stock intake. Please disconnect battery terminals before installation.
2. Remove plastic battery ram air.
3. Disconnect Crank case line and remove plastic fitting. Save for later install (See step 11).
4. With 10mm wrench loosen loosen VSV valve on air box, disconnect and remove. Save for later install (See step 11).
5. With 10mm socket or wrench […]

[Read more →]