Automotive Manual, Car Parts and News

MOUNTING LOCATION: The enclosure mounts behind the seat of a regular cab truck.
INSTALLATION: Follow the steps below
1. Move seat and seat back all the way forward. You do not need to remove the seat.
2. If truck is equipped with a rear tool tray, this tray must be removed to mount enclosure. Remove rubber caps to […]

[Read more →]

The following information describes the installation procedure for the M-11572-GT “ENGINE START” push-button
into a 2005-‘09 Mustang.
STEP 1: Start by removing the (2) screws found at the rear of the center console underneath the armrest.
STEP 2: Remove the trim plate which surrounds the Shifter Handle (Auto) or Shifter Boot (Manual).
Note: Manual transmission applications will require removing […]

[Read more →]

Schefenacker recommends that this installation be carried out by a professional installer. Please read ALL the instructions and warnings thoroughly before installing the Telescopic Trailer Tow Mirrors.These mirrors are designed only for the vehicles listed on this page. Ensure that the fitting instructions are followed exactly,as failure to do so may result in incorrect installation,and […]

[Read more →]

Pillar installation Directions: Read directions before starting installation Model# (17212 Dual), (17213 Triple) Fits 03+ Dodge Ram
1)  Remove Stock Pillar by removing the two  screws located under the caps of pillar handle.
2)  Install Gauges in new pillar.
3)  Tape or secure gauge wiring to back of pillar.
4)  Install new pillar in place of old pillar.
5)  Use provided screw to hold pillar in place:
•  Make sure screw is aligned with factory hole to avoid cross threading
•  Don’t over tighten screw.

[Read more →]

Thank you for purchasing Figure’s 2005-Present Dodge Charger Grille set. These grilles are fabricated employing quality materials and finishes, and have been engineered to enhance the look of your vehicle for the duration of its life. Proper installation is essential to your overall satisfaction, so please read these instructions before attempting to install the grilles. […]

[Read more →]

List of tools and additional parts required
Masking tape, clear tape, black mastic, hammer, centre punch
Assorted screw drivers, sockets and spanners 103mm (4”) hole saw
Assorted drill set, wet / dry sand paper, ½ round file, small square file, Zinc rich primer.

[Read more →]

Procedure A1 – Door Panel Removal: Dakota/Durango (See A2 for Ram Van and A3 for Ram Pickup)
1) Lower window.
2) Remove 5 screws holding door panel in place.
3) Gently raise door panel to expose door wiring.
Procedure B1 - Mirror Housing Removal: Dakota/Durango (See B2 for Ram Van and B3 for Ram Pickup)
1) Unplug the connections for […]

[Read more →]

Removing the stock air inlet system:
a) Loosen the five screws securing the stock air box lid. Remove the air box lid from the vehicle.
b) Remove the Inlet Air Temperature (IAT) sensor. The metal band will need to be pried off with a flat-head screwdriver. Use care to avoid damaging the IAT sensor.
c) Remove the air […]

[Read more →]

Step 1: Pull up on the shifter bezel. There are several clips that hold it in place. It will still be attached to the shifter if you have a manual shift, so you’ll need to remove the shifter handle by removing the two 13mm bolts on the shifter.
Step 2: Remove the upper center console half. […]

[Read more →]

Schefenacker recommends that this installation be carried out by a professional installer. Please read ALL the instructions and warnings thoroughly before installing theTelescopic Trailer Tow Mirrors.These mirrors are designed only for the vehicles listed on this page. Ensure that the fitting instructions are followed exactly, as failure to do so may result in incorrect installation, […]

[Read more →]