Automotive Manual, Car Parts and News

2002 Mazda Truck MPV V6-3.0L DOHC – Vehicle Level – Lighting and Horns – Headlamp – Service and Repair – Front Combination Light
FRONT COMBINATION LIGHT REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove in the order indicated below.
- Fastener – Front combination light (See Front Combination Light Removal Note) – Connector – Socket – Front turn [...]

[Read more →]

Headlight and Turn Signal Control for 2007 Nissan 350Z
HEADLIGHT SWITCH – Turn the headlight switch to the position to turn on the front parking, side marker, tail, license plate and instrument panel lights. – Turn the headlight switch to the position to turn on the headlights. All other lights remain on.
HIGH BEAM – Push the [...]

[Read more →]

REMOVAL & INSTALLATION Front Turn Signal and Parking Lights CRV MODELS AND V6 ODYSSEY MODELS
1. Turn the steering wheel in the opposite direction from which the bulb is to be removed.
2. Using a flat blade screwdriver, remove the fasteners securing the inner fender behind the headlight and pull back on the
inner fender liner.
3. Remove the [...]

[Read more →]

PRE INSTALLATION
1. Read entire instruction sheet before proceeding.
2. Run OBD II diagnostics and repair or replace any malfunctioning components before installation.
3. Make sure vehicle is parked on a level surface and set the parking brake.
4. Disconnect both battery terminals.
5. If engine has run within the past two hours let it cool down.
6. Chock the rear [...]

[Read more →]

Tools Reqd: ratchet with 8mm and 10mm sockets (extension not required), small flat blade screwdriver, small phillips head screwdriver.
Open the hood and prop it up.
Remove the four 10mm bolts (see photo)
Remove the quick-lock fasteners holding the weather trim piece in place. They are removed using a small Phillips screwdriver.
Remove the 4 quick-lock fasteners in the [...]

[Read more →]

Removing the stock air inlet system
a) Before removing any of the O.E. components, label each individual part so that no components become mixed up during the installation process.
b) Unclip the hard plastic breather hose from the breather nipple by squeezing the blue retaining clip. Slide the purge solenoid valve (PSV) toward the back of the [...]

[Read more →]