Automotive Manual, Car Parts and News

The following information describes the installation procedure for the M-11572-GT “ENGINE START” push-button
into a 2005-‘09 Mustang.
STEP 1: Start by removing the (2) screws found at the rear of the center console underneath the armrest.
STEP 2: Remove the trim plate which surrounds the Shifter Handle (Auto) or Shifter Boot (Manual).
Note: Manual transmission applications will require removing […]

[Read more →]

STEP 1. Set emergency brake. Place gear selector away from dash. Open ashtray, depress push lever, and remove ashtray. Remove small trim insert located between flasher and defrost button by hooking small indent in the trim piece with hook tool and pulling out , set aside. Using Phillips screwdriver, locate and remove Phillips screw located […]

[Read more →]

Step 1: Position truck on a flat surface and lift the front wheels off the ground using jack stands or a (2) two post lift if available. Remove the wheels and tires on both sides. Remove the two lower sway bar nuts on both sides of truck. (Insert A) Remove the driver’s side cotter pin […]

[Read more →]

Step 1:
Position truck on a flat surface and lift the front wheels off the ground using jack stands or a (2) two post lift if available. Remove the wheels and tires on both sides. Remove the two lower sway bar nuts on both sides of truck. (Insert A)
Remove the driver’s side cotter pin and loosen […]

[Read more →]

Each factory headlight is bolted to the car by only (3) nuts. Once the (3) nuts are unscrewed the headlight will be able to be removed from where it is bolted. In order to completely remove the headlight from the car you will have to unplug the factory wiring harness from the back of the […]

[Read more →]