Automotive Manual, Car Parts and News

FRONT :
1.With vehicle on flat level ground, set the emergency brake and block the rear tires. Place floor jack under the lower control arm’s front cross member and raise vehicle. Place jack stands under frame rails, behind the front wheel wells, then lower the frame onto the stands. Remove the factory skid plate.
2. Remove the […]

[Read more →]

Get ready to install the kit.
1. Remove the shift transfer case shift linkage.
a. If present on your vehicle, remove four bolts and skid plate from the frame under the transmission and transfer case.
b. Remove two rubber bushings and transfer case shift linkage from shift lever and transfer case.
2. Remove the front bumper.
a. Remove nine panel […]

[Read more →]

Read instructions before assembling. Fasteners should be finger tight until instructed to tighten according to the torque chart. Use standard methods and practices when attaching snowplow including proper personal protective safety equipment.
MOUNT INSTALLATION
1. If the vehicle is equipped with a stamped-steel splash guard and/or tow hooks, remove them. Retain the splash guard, tow hooks, and […]

[Read more →]

The recommended push beam height for this undercarriage assembly is 10-1/2″ from the center of the push beam to level ground. DO NOT exceed 12-1/2″ in height for this undercarriage.
WARNING: Always perform vehicle undercarriage installations with the keys removed from the vehicle’s ignition. Properly tag the ignition switch to alert others work is being performed […]

[Read more →]