Automotive Manual, Car Parts and News

The BedLocker also offers an optional wire harness (part # BL1120) to manually operate the tonneau cover from inside the cab of your truck. This harness is designed to plug into the custom-built electronics control box mounted inside the canister. Thread the plug through the side of the canister and connect it to the grey/violet [...]

[Read more →]

1) Disconnect the battery.
2) Open door completely and loosen the door catch that is attached to the inner frame and the door. Later we’ll remove it.
3) Remove fender:
Remove all 6 screws that are attached to the inner fender well.
Remove (2) 10mm bolts that secure the bumper to the fender.
After removing the (2) 10mm bolts you [...]

[Read more →]

The Bedlocker is designed to carry rainwater from the cover into the canister and then out through the drains. Most truck models have standard OE drain holes or plastic/rubber access ports in the front of the truck bed. Check to make sure your truck has the OE drain holes so that drilling into the sheet [...]

[Read more →]

1) Disconnect the battery.
2) Remove fender:
Remove all Phillip’s screws or fasteners from the wheel well. Usually you will have to remove bolts to loosen the bumper Remove all bolts from the bottom of the fender by the door. Remove bolts from the top of the fender. Usually you will have to remove (1) bolt holding [...]

[Read more →]

Running the cables through the headrest posts
You will need to route the cables through the headrest posts. The following steps will guide you through this process.
Step 1: Locate a clean, non-abrasive working surface. Unwrap the headrest bucket and place the AV7000 electronics system above the headrest bucket as shown in figure 1.
Step 2: Position the [...]

[Read more →]