Automotive Manual, Car Parts and News

Installation Instructions:
Flip up rear seats.
- Remove the jack from under the back seat (01― - 03 trucks). Jack should be installed with an angle bracket, wing nut and seat belt or with two wing nuts. (00 - 01― trucks have jack installed under the front seat.)
- Slide the passenger side end of the DU-HA against […]

[Read more →]

The recommended push beam height for this undercarriage assembly is 12-1/2″ from the center of the push beam to level ground. DO NOT exceed 14-1/2″ in height for this undercarriage.
WARNING: Always perform vehicle undercarriage installations with the keys removed from the vehicle’s ignition. Properly tag the ignition switch to alert others work is being performed […]

[Read more →]

Installation Instructions: Solid Bench Seat
Step One: Tilt the back of the rear seat forward. Remove jack handles from current plastic tray (if applicable). Using an 8mm socket remove bolts holding current plastic tray. Remove tray from truck. If you experience problems removing bolts you may need to apply upward pressure from under tray.
Step Two: Set […]

[Read more →]

Although this hitch is designed to safely tow its rated load, we recommend that you consult your vehicle owner’s manual for possible manufacturer’s recommendations or limitations. Always follow the manufacturer’s installation instructions and always install on the specified vehicle. Before installing hitch, check that the attachment points are in good condition. Failure to follow these […]

[Read more →]

The Uprev Cipher and Osiris software/cable requires the factory CAN wiring to be extended to the OBDII port under the dash of 04-06 Nissan Sentras in order for them to properly interface with the Factory ECU. To do this, you must first locate the CAN HI and Can LO wires coming from the ECU into […]

[Read more →]

Installation of this baseplate requires removing the bumper.
1. Read the General Instruction Sheet included with this baseplate.
2. The baseplate mounts to the vehicle using the four bolts that mount the bumper to the frame and two bolts into the frame. All bolts are provided with the baseplate.
3. The bumper of the pickup will be removed […]

[Read more →]

The third-generation Mazda RX7 (FD3S) suffers from fuel starvation issues when driven aggressively, especially on vehicles with R-compound tires. This problem is caused by particularly wide and shallow fuel tank with an off-center pump location which is offset to the driver’s side. Under hard acceleration to the left, the fuel in the tank is forced […]

[Read more →]

For easier assembly and installation, vehicle and all snowplow components should be on a smooth, level, hard surface, such as concrete.
1. Remove the bumper and retain the fasteners. If there is a plastic attachment below the radiator, remove it and retain those fasteners as well.
2. Hold the front mount so the holes on the mount’s […]

[Read more →]

All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.
STEP 1.
Insert the two (2) radio removal tools into the slots on the face of the radio. NOTE: Make sure the […]

[Read more →]