Automotive Manual, Car Parts and News

1. Start by supporting the truck on 4 jack stands. The truck should be sitting on approximately the same angle as it does on the ground, or slightly lower in front.
2. Remove all the old front suspension components, including the leaf springs and the engine mounting rails. Also remove the spring perches from the frame […]

[Read more →]

1. Start your installation by supporting the truck on 4 jack stands. The truck should be sitting on the approximate angle that it does on the ground, or slightly lower in front.
2. Begin by removing all the stock suspension components from the frame. The front crossmember should be left in place.
3. Boxing the rails is […]

[Read more →]

THIS KIT INCLUDES LOCK NUTS WHICH REQUIRE TIGHTENING WITH A WRENCH AFTER BEING STARTED BY HAND.
1. As shown in photo one (1), place D-shaped poly-bushings onto straight areas of the bar on each side of center hump. After installing D-bushings onto bar, place U-plates on D-bushings.
2. Place U-bolts on axle tubes next to casting as […]

[Read more →]

Step 1: Prior to lifting the vehicle it is recommended that you measure the stock height of the vehicle so that you have a base line to gauge the height of the vehicle. Measure the vehicle from the bottom of the wheel to the lip of the fender. Position truck on a flat surface and […]

[Read more →]

STEP 1: PREASSEMBLY INSPECTION
All parts should be examined for any damage during the shipping and handling process. Measurement should be taken to ensure parts meet applications requirements, such as hub and shaft fits, shaft separation, etc. All parts must be clean and free of any foreign material before attempting assembly.
STEP 2: INSTALLATION OF KEYS
Install keys […]

[Read more →]

1. Remove the bumper and adjustable bumper mount plates from the truck frame rail. NOTE: The fascia will need to be permanently removed or notched for reinstallation. Discard mount plate hardware.
2. Install the support arms (Ref 8 & 9) to the truck frame rail. The passenger side will install behind the front stabilizer bar and […]

[Read more →]

For easier assembly and installation, vehicle and all snowplow components should be on a smooth, level, hard surface, such as concrete.
1. Remove bumper from bumper brackets. Retain fasteners.
2. Remove bumper brackets from frame. Diesel and V10 applications: On these applications you must first remove the top two intercooler fasteners. Then push intercooler up and out […]

[Read more →]

Although this hitch is designed to safely tow its rated load, we recommend that you consult your vehicle owner’s manual for possible manufacturer’s recommendations or limitations. Always follow the manufacturer’s installation instructions and always install on the specified vehicle. Before installing hitch, check that the attachment points are in good condition. Failure to follow these […]

[Read more →]

1) Front brackets are identical and are simply turned 180 degrees out so face of bracket is facing outside of truck.
2) Bars can be mounted either side and are identical.
3) Body mount torque is 65 ft.-lbs.
4) Holes in rocker panel are usually covered with black or grey tape from manufacturer

[Read more →]

FRONT OF VEHICLE
1. Park vehicle on level concrete surface.
2. Center and lock the steering wheel.
3. Block the rear wheels of the vehicle to prevent vehicle from moving in either direction.
4. Remove the upper track bar bolt using an 18mm socket and save bolt for later reinstall. See Figure A.
5. Remove the lower front shock bolts […]

[Read more →]