Automotive Manual, Car Parts and News

1. Start by supporting the truck on 4 jack stands. The truck should be sitting on approximately the same angle as it does on the ground, or slightly lower in front.
2. Remove all the old front suspension components, including the leaf springs and the engine mounting rails. Also remove the spring perches from the frame […]

[Read more →]

1. Start your installation by supporting the truck on 4 jack stands. The truck should be sitting on the approximate angle that it does on the ground, or slightly lower in front.
2. Begin by removing all the stock suspension components from the frame. The front crossmember should be left in place.
3. Boxing the rails is […]

[Read more →]

Prior to installation, carefully inspect the vehicle’s steering and drive train components. Be sure to check ball joints, tie rod ends, pan-rod bar, and control arm bushings. Everything must be tight and in good working condition.
• We recommend installation be done by a trained professional
• Read instructions carefully before attempting installation
• Secure and properly block […]

[Read more →]

The drop link is fully rose-jointed and is a direct replacement for the original unit. Instead of using rubber bushes to provide the articulation, it uses two rod ends to provide smoother movement — and an end to regular bush replacement. NOTE: the front and rear drop links are identical and these fitting instructions cover […]

[Read more →]

Installation Instructions: Disconnect the negative battery cable and then disconnect the positive battery cable. Disconnect the wiring, remove the belt, and then remove the stock alternator from it’s mounting brackets. Mount the new alternator to the existing mounting bracket on the engine with the double feet from the alternator on either side of the mounting […]

[Read more →]

Specially designed adapters are used in conjunction with Universal Anchoring System (UAS) stands and Universal Measuring System (UMS) pinchweld stands when securing vehicles with horizontal pinchwelds and vertical jack tabs in the corners of their center sections. (All Honda / Accord / Acura vehicles excluding Odessey.) These adapters allow the positioning of vertical jack tabs […]

[Read more →]

BMW 3 Series (with side jack lifting holes) Clamping Setup
1. Remove conventional clamp jaws.
2. Attach BMW clamping adapter (518315), 1/4 inch spacer (532196) and outer pin support (518313) to pinchweld clamps as shown.
3, Remove plugs in bottom of rocker panels and jacking holes.
4. Lower vehicle onto supports while guiding outer support pins (618302) into jacking […]

[Read more →]

Specially designed adapters are used in conjunction with Universal Anchoring System (UAS) stands and Universal Measuring System (UMS) pinchweld stands when securing vehicles with horizontal pinchwelds and vertical jack tabs in the corners of their center sections. (All Honda / Accord / Acura vehicles excluding Odessey.) These adapters allow the positioning of vertical jack tabs […]

[Read more →]