Automotive Manual, Car Parts and News

Diesel Turbo Lifesaver (DTLS) is a computer controlled device that allows you to set an automatic engine idle sequence to properly cool your turbocharger before engine shutdown as required by Ford and Navistar. Failure to follow recommended turbo cooling procedures can lead to premature bearing failure that is NOT covered under the factory warranty. Installing […]

[Read more →]

Plug the module into the diagnostic port. The diagnostic port is under the dash, below and to the left of the steering column. Secure the device up under the dash where it will not be in the way. Attach dpf emulator and pressure sensor emulators.
IMPORTANT: Wait at least 15 seconds after key is on before […]

[Read more →]

Dodge Caliber, Jeep Compass Subwoofer Installation
1. Lift up on the B pillar post cover and then pull it towards the center of the car to remove.
2. Using a panel removal tool gently pry up the threshold/kick panel along the bottom of the front and rear door openings to release fasteners and remove panel.
3. Find the […]

[Read more →]

The Uprev Cipher and Osiris software/cable requires the factory CAN wiring to be extended to the OBDII port under the dash of 04-06 Nissan Sentras in order for them to properly interface with the Factory ECU. To do this, you must first locate the CAN HI and Can LO wires coming from the ECU into […]

[Read more →]

The Steering Wheel Interface (SWI) will control most aftermarket head units with an infrared remote by still utilizing the factory steering wheel radio control buttons. The SWI has non-volatile memory which can store from between 1 to 17 functions from the steering wheel and wireless remote. *The SWI interfaces will only work with infrared remotes […]

[Read more →]

ALARM/SIREN POSITION
Position the compact alarms and the sirens in the engine compartment, on the bulkhead of the support of the passenger’s side shock absorber. Pass the cables through the rubber sleeve above the lung of the servobrake.
POWER SUPPLY
+ 30: connect to the 4 mm2 WHITE/RED wire located in the multiway connector placed behind the fuse […]

[Read more →]

INSTALLATION PREPARATION:
1. DISCONNECT NEGATIVE BATTERY CABLE BEFORE INSTALLATION.
2. REMOVE THE STEERING COLUMN SHROUD AND LOWER DASH PANEL.
HARNESS INSTALLATION:
1. LOCATE THE WHITE CONNECTOR AT THE IGNITION SWITCH. CONNECT THE RED IGNITION WIRE (+12V IGNITION) FROM THE MAIN CRUISE HARNESS TO THE GREEN/RED WIRE OF THE IGNITION SWITCH CONNECTOR.
2. LOCATE THE YELLOW 12-PIN CLOCK SPRING CONNECTOR AT […]

[Read more →]

Plug brake control adapter into mating receptacle on backside of brake control before attaching to the vehicle connector.
1. Locate the vehicle’s electric brake control harness connector. The harness will be located underneath the dash and left of the steering column, taped to another harness near the emergency brake pedal. There will be a 4-pin connector […]

[Read more →]

The Honda/Acura Immobilizer anti-theft system uses a low-power transponder mounted in the head of the ignition key. When the vehicle is started, the Key Cylinder Module converts the transponder signal and sends a secure, coded signal to the Engine Control Module. If the signal to the Engine Control Module is correct, the vehicle will start.

[Read more →]

The 2010 BMW 325i has got an extensive range of standard features comprising of climate-controlled center console, climate control electrochromatic inside, Logic 7 audio system with digital sound processing and 13 speakers, leather-wrapped steering wheel with tilt/telescoping steering column, cruise control, power windows, automatic bi-xenon adaptive headlamps with washers, 17-inch wheels with H-rated tires, remote […]

[Read more →]