Automotive Manual, Car Parts and News

What you will need for assembly:
1- socket wrench
1- 9/16 socket
1- Metric 13 socket (Prius uses metric bolts however a 9/16 works)
1- 9/16 flat wrench
1- protective eyewear
Step 1- Remove the 2 Black extendmyseat brackets from the packaging and locate the 4 black 3/8” provided bolts.
Step 2- Go to your vehicle with a socket wrench and a […]

[Read more →]

While the install is fairly straight forward, please review these instructions carefully before attempting installation. If you do not feel comfortable installing this kit on your own, contact a professional installer in your area.
Step 1: Remove factory vent by popping it out from the sides with the small flathead screwdriver. Grasp the edge of the […]

[Read more →]

Emergency Brake Cable Installation
Step 1: Lay out housing the length of vehicle with end fittings toward the rear of vehicle.
Step 2: Install backing plate fitting into backing plate bracket with nylock nut supplied in kit. Backing plate bracket is part of brake system. This is not supplied by Lokar.
Step 3: Begin to route outer housing […]

[Read more →]

Instructions Procedure:
Step 1: Position truck on a flat surface and lift vehicle by the frame so that the front wheels are off the ground. Use a floor jack and jack stands or a (2) two post lift if available. Next locate the torsion key cross member under the cab of the truck.
Step 2: Mark the […]

[Read more →]

New Ford vehicles have a new electronic sensor installed in the transmission and the speedometer cable clips into the back of the electronic sensor. (See cable drive unit) our adapter kit and transmission sensor is installed on the transmission side of the electronic sensor. Do not remove the speedometer cable fromthe back of the electronic […]

[Read more →]

The following information describes the installation procedure for the M-11572-GT “ENGINE START” push-button
into a 2005-‘09 Mustang.
STEP 1: Start by removing the (2) screws found at the rear of the center console underneath the armrest.
STEP 2: Remove the trim plate which surrounds the Shifter Handle (Auto) or Shifter Boot (Manual).
Note: Manual transmission applications will require removing […]

[Read more →]

Schefenacker recommends that this installation be carried out by a professional installer. Please read ALL the instructions and warnings thoroughly before installing the Telescopic Trailer Tow Mirrors.These mirrors are designed only for the vehicles listed on this page. Ensure that the fitting instructions are followed exactly,as failure to do so may result in incorrect installation,and […]

[Read more →]

Step 1: Prior to lifting the vehicle it is recommended that you measure the stock height of the vehicle so that you have a base line to gauge the height of the vehicle. Measure the vehicle from the bottom of the wheel to the lip of the fender. Position truck on a flat surface and […]

[Read more →]

Before installation of the Air Ride unit, prepare a smooth, flat, hard surface and have all tools and equipment needed for the job. Chock the front wheels of the truck, to prevent it from rolling forward or rearward. Place a jack on each side of frame ahead of the rear springs, front bolts.

[Read more →]

- Complete Stock Intake.
- With 5/16” nut driver loosen clamps on OE tube at turbo/air box and remove. Loosen clamp at turbo and disconnect crank case line with pliers. Remove tube.
- Disconnect air temp & MAF sensor. Loosen 10mm nut holding in front of air box using wrench or socket. Lift up and pull OE […]

[Read more →]