This system is designed to use the stock hanger locations. Please check the alignment of your OEM system before installation. If the tips of your OEM system are not straight or centered in the rear valance, then the replacement system will also be misaligned.
2009 Hyundai Genesis Stillen Cat-Back Exhaust System
March 20th, 2011 · No Comments
1986-91 Chevrolet Camaro/Pontiac Firebird Flowmaster Force II System
February 14th, 2011 · No Comments
Removal:
1) Raise the rear of the vehicle and support with jack stands.
2) Support the stock muffler with a stand and unbolt the left side tailpipe hanger.
3) Using a hacksaw or sawsall, cut the muffler inlet pipe where it enters the muffler case. Remove the muffler/tailpipe assembly from underneath the vehicle.
2010 Chevrolet Camaro V8 Axle-Back Systems Instructions
February 13th, 2011 · No Comments
6210SR5 (with street/race mufflers) and 6210D5 (muffler delete system) ( installs with either stock H-pipe or Bassani Power-X crossover)
Note: these systems can be installed with either the factory mid-pipe assembly or a Bassani Power-X crossover pipe for this application. Please see the instructions included with the Bassani Power-X crossover to explain installation with that component.
05-09 V6 Ford Mustang dual exhaust system with Power-X crossover
August 8th, 2010 · No Comments
Installation instructions:
1.) Raise and support vehicle.
2.) Remove stock muffler from vehicle by un-bolting hangers from frame, loosening inlet clamp, and lowering unit out from under vehicle with hangers still attached to muffler.
3.) Loosen clamp attaching factory over-axle pipe to vehicle Y-pipe and remove over-axle pipe from vehicle.
4.) Use a reciprocating saw and cut both legs [...]
