Automotive Manual, Car Parts and News

The mounting procedure outlined below covers 1994 & newer 4 X 4 DODGE ū and 1 ton and 1994 - 1996 4 X 4 DODGE ― ton trucks. You will need to refer to the illustrations and familiarize yourself with each of the undercarriage components and their relative position to each other. Then proceed as […]

[Read more →]

Remove air cleaner assembly.
a) Disconnect air tube from air box.
b) Remove air box lid and filter.
c) Remove air cleaner assembly from fender. Loosen nut at rear near washer reservoir. Remove plastic stud from filter box snout, then remove assembly from vehicle.

[Read more →]

PROCEDURE
1. Begin installation by working on driver side of the vehicle starting at the front of the inner rocker panel.
2. Located on the inside as well as the bottom inner of the rocker panel you will see one thread hole and one thread stud for each mounting bracket refer to diagram 1. (Note all brackets […]

[Read more →]

1. Install one Miata Lo-Pro Headlight con- version at a time starting with the Drivers side first. Please note that when “Right” or “Left” is mentioned, it is referenced from behind the steering wheel. With the headlights and the hood in the UP position remove the black plastic mask by removing the four phillips (cross) […]

[Read more →]

1) Getting started
a) Make sure vehicle is parked on a level surface.
b) Set parking brake.
c) Disconnect negative battery terminal.
d) If engine has run within the past two hours let it cool down.

[Read more →]