Automotive Manual, Car Parts and News

Installation
1. Place the coach on a level concrete surface. Measure each side of the coach from the front wheel well to the ground. Record these measurements as you will need them in Step 9.
2. Place a jack under each side of the frame just behind the leaf spring shackles. Jack the coach up high enough […]

[Read more →]

Remove air cleaner assembly.
a) Disconnect air tube from air box.
b) Remove air box lid and filter.
c) Remove air cleaner assembly from fender. Loosen nut at rear near washer reservoir. Remove plastic stud from filter box snout, then remove assembly from vehicle.

[Read more →]

Most 17” wheels will clear the outer diameter of the caliper for a 328mm or 332mm rotor kit. For a 355mm kit, a minimum 18” wheel is typically required, and for a 380mm rotor kit, a minimum 19” wheel is needed. The more critical clearance, however, is the gap between the spokes of the wheel […]

[Read more →]

FRONT OF FRONTIER
1. Park vehicle on level concrete surface.
2. Center and lock the steering wheel.
3. Block the rear wheels of the vehicle to prevent vehicle from moving in either direction.
4. Jack up the vehicle from the lift point in Figure A.
5. Support the vehicle with jack stands from the points in Figure A.
6. Remove the […]

[Read more →]

The drop link is fully rose-jointed and is a direct replacement for the original unit. Instead of using rubber bushes to provide the articulation, it uses two rod ends to provide smoother movement — and an end to regular bush replacement. NOTE: the front and rear drop links are identical and these fitting instructions cover […]

[Read more →]

The AA cat back exhaust system is a fine exhaust system that will deliver a deeper sound, increased torque and horsepower. Many hours of design, testing and fitting were conducted for a clean fit and finish.
Locate the 6 pins that hold the rear valance along the back side lower edge. Remove them so that the […]

[Read more →]