Automotive Manual, Car Parts and News

KING PIN TRAILER PLATE INSTALLATION:
FOR KING PIN BOXES WITH A FLANGE:
1. Place the Trailer Plate {J2} over the King Pin, with the guide wedge towards the rear of the trailer (wedge facing down). Align the Trailer Plate {J2} square with the king pin box and clamp in place to prevent movement.
2. Mark the holes for […]

[Read more →]

Step 1: Pull up on the shifter bezel. There are several clips that hold it in place. It will still be attached to the shifter if you have a manual shift, so you’ll need to remove the shifter handle by removing the two 13mm bolts on the shifter.
Step 2: Remove the upper center console half. […]

[Read more →]

The following instruction should be followed to install the king pin Trailer Plate.
FOR KING PIN BOXES WITH A FLANGE:
1. Place the Capture Plate {J2} over the king pin, with the guide wedge towards the rear of the trailer (wedge facing down). Align the Capture Plate {J2} square with the king pin box and clamp in […]

[Read more →]

Getting started
- Chock the other 3 wheels on both sides
- Release handbrake
- Put the gearbox into neutral
- Loosen wheel nuts
- Jack up the car
- Remove wheel nuts + wheel
- Place jack-stand under car for safety

[Read more →]

1. Unscrew the shift knob and remove the boot.
2. Remove cover which houses the lighter assembly. There are four clips holding it to the center console, they just pop out.
3. Unplug the lighter assembly. Below you can see the cover off and the four clips which hold it to the center console.
4. Remove the two […]

[Read more →]