Automotive Manual, Car Parts and News

1. Turn off the ignition and disconnect the negative battery cable.
2. Loosen the hose clamp at the intake resonator as shown.
NOTE: Disconnecting the negative battery cable erases pre-programmed electronic memories. Write down all memory settings before disconnecting the negative battery cable. Some radios will require an anti-theft coded to be entered after the battery is […]

[Read more →]

1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen the hose clamp and remove the air tube from the throttle body air box.
3. Disconnect the air temperature sensor connector attached to the air box.
4. Loosen the two bolts that secure the air box using a 10mm socket.
5. Remove the oil filler cap (for clearance if needed) and […]

[Read more →]

To begin the installation of your new Adrenaline box, first make sure the ignition is in the off position and key is removed from the ignition. We also recommend disconnecting your batteries for extra safety.* When routing wires pay special attention to avoid any moving, sharp, or hot engine components! Now choose a suitable mounting […]

[Read more →]

To Start the installation:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Unlock the red locking tab on the air temperature sensor electrical connection, then depress the locking lever and pull apart the temperature sensor electrical connection
3. Loosen the hose clamp that secures the intake tube to the throttle body and pull […]

[Read more →]

PowerAid Throttle Body Spacer Installation Instructions for 03-08 Dodge Ram 5.7L Hemi
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen the hose clamp and remove the air tube from the throttle body air box.
3. Disconnect the air temperature sensor connector attached to the air box.
4. Loosen the two bolts that secure the air box using a 10mm […]

[Read more →]

The front fascia and tie down brackets are removed for baseplate installation. Tie down brackets will not be reinstalled. No drilling necessary. The BX8869 is available for the vehicle. Attachment Tabs are 22 inches center to center and a height of 15 5/8 inches.
1. Remove two phillips screws from under fascia corner, just forward of […]

[Read more →]

- Loosen AFM clamp (1) securing the crossover tube (4) to the AFM
- Unplug the AFM connector (2) by pushing down on the tab and pulling away. Do not pull on the wires.
- Remove the three plastic clips securing the air temp sensor wire to the air box.
- Separate the crossover tube (4) from the […]

[Read more →]