Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen (2) hose clamps and remove rubber hose. (Ref. “C”)
3. Remove compression ring. (Ref. “B”)
4. Install power plate with a small amount of grease on the installing edge of the power plate for ease of installation. (Ref. “A”)
99-00 Ford F-250/F-350/F-550 Powerstroke 7.3L PowerAid Throttle Body Spacer Instructions
January 18th, 2010 · No Comments
03-05 Dodge Ram 5.7L Hemi PowerAid Throttle Body Spacer Installation Instructions
January 3rd, 2010 · No Comments
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen the hose clamp and remove the air tube from the throttle body air box.
3. Disconnect the air temperature sensor connector attached to the air box.
4. Loosen the two bolts that secure the air box using a 10mm socket.
5. Remove the oil filler cap (for clearance if needed) and […]
03-08 Dodge Ram 5.7L Hemi PowerAid Throttle Body Spacer Installation
November 27th, 2009 · No Comments
PowerAid Throttle Body Spacer Installation Instructions for 03-08 Dodge Ram 5.7L Hemi
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen the hose clamp and remove the air tube from the throttle body air box.
3. Disconnect the air temperature sensor connector attached to the air box.
4. Loosen the two bolts that secure the air box using a 10mm […]
94-01 Dodge Ram 3.9L, 5.2L PowerAid Throttle Body Spacer Installation Instructions
November 26th, 2009 · No Comments
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove the air cleaner.
3. Using 1/2” socket, remove (4) 5/16” bolts attaching the throttle body to the manifold.
4. Lift the throttle body.
5. Remove the old gasket and clean both the throttle body and manifold surfaces.
6. Install power plate with (2) gaskets. (Ref. A)
99-04 Nissan Xterra/Frontier 3.3L PowerAid Throttle Body Spacer Instructions
November 18th, 2009 · No Comments
PowerAid throttle Body spacer instruction for Nissan Xterra/Frontier:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body air intake assembly.
3. Remove (4) bolts from the throttle body. (Ref. “C”)
4. Remove gasket and clean surfaces.
5. Remove bolts from the throttle linkage bracket and save.
05-09 Nissan Frontier/Xterra/Pathfinder 4.0L V6 PowerAid Throttle Body Spacer Instructions
November 15th, 2009 · No Comments
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body air intake system.
3. Remove (4) bolts from the throttle body. (Ref. “A”)
4. Install power plate using (4) 6mm bolts and (4) 6mm washers. (Ref. “B”)
* Note: Install the ‘O’-ring in the power plate and face towards the throttle body.