Installation Instructions the Throttle Body Spacer for Ford Mustang:
DISCONNECT NEGATIVE (-) BATTERY CABLE.
Remove air cleaner housing from the throttle body.
Remove (3) bolts and (1) stud from the front side of the throttle body. (Ref. “D”)
Remove (2) bolts from the throttle linkage bracket.
Move throttle body away from intake manifold. Remove old gasket and clean surfaces.
Install power […]
94-98 Ford Mustang 3.8L V6 Throttle Body Spacer
August 7th, 2010 · No Comments
1998-01 Ford Ranger/Mazda K&N Air Intake Kit Installation
June 5th, 2010 · No Comments
FAILURE TO FOLLOW INSTALLATION INSTRUCTIONS AND NOT USING THE PROVIDED HARDWARE MAY DAMAGE THE INTAKE TUBE, THROTTLE BODY AND ENGINE. 1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable. 2. Disconnect the mass air sensor electrical connection as shown. 3. On vehicles equipped with an air temperature sensor disconnect the electrical connection […]
1997-2003 DODGE Dakota/Durango 2.5, 3.9, 5.2, 5.9L Engines Air Intake System Instructions
November 28th, 2009 · No Comments
Remove air cleaner assembly.
a) Disconnect air tube from air box.
b) Remove air box lid and filter.
c) Remove air cleaner assembly from fender. Loosen nut at rear near washer reservoir. Remove plastic stud from filter box snout, then remove assembly from vehicle.
94-01 Dodge Ram 3.9L, 5.2L PowerAid Throttle Body Spacer Installation Instructions
November 26th, 2009 · No Comments
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove the air cleaner.
3. Using 1/2” socket, remove (4) 5/16” bolts attaching the throttle body to the manifold.
4. Lift the throttle body.
5. Remove the old gasket and clean both the throttle body and manifold surfaces.
6. Install power plate with (2) gaskets. (Ref. A)
99-04 Nissan Xterra/Frontier 3.3L PowerAid Throttle Body Spacer Instructions
November 18th, 2009 · No Comments
PowerAid throttle Body spacer instruction for Nissan Xterra/Frontier:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body air intake assembly.
3. Remove (4) bolts from the throttle body. (Ref. “C”)
4. Remove gasket and clean surfaces.
5. Remove bolts from the throttle linkage bracket and save.
05-09 Nissan Frontier/Xterra/Pathfinder 4.0L V6 PowerAid Throttle Body Spacer Instructions
November 15th, 2009 · No Comments
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body air intake system.
3. Remove (4) bolts from the throttle body. (Ref. “A”)
4. Install power plate using (4) 6mm bolts and (4) 6mm washers. (Ref. “B”)
* Note: Install the ‘O’-ring in the power plate and face towards the throttle body.
SB-Chevy Engine Cover Kit Installation Instructions for 50060
September 30th, 2009 · No Comments
On behalf of the designers, we hope you enjoy your new engine dress up system. Whether you are giving your engine compartment a new look or creating one on a project car, this kit will give you what you need and the safety you demand.
Note: Although much research and design has gone into this item […]