Automotive Manual, Car Parts and News

Incorrect or out of phase engine timing can result in mechanical contact between the valve head and the piston crown causing serious damage to the engine. No responsibility can be accepted for any loss or damage arising from the incorrect use of this kit. For 1.6 and 1.8 diesel engines as fitted to Ford Fiesta, […]

[Read more →]

1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen the hose clamp and remove the air tube from the throttle body air box.
3. Disconnect the air temperature sensor connector attached to the air box.
4. Loosen the two bolts that secure the air box using a 10mm socket.
5. Remove the oil filler cap (for clearance if needed) and […]

[Read more →]

STEP 1: PREASSEMBLY INSPECTION
All parts should be examined for any damage during the shipping and handling process. Measurement should be taken to ensure parts meet applications requirements, such as hub and shaft fits, shaft separation, etc. All parts must be clean and free of any foreign material before attempting assembly.
STEP 2: INSTALLATION OF KEYS
Install keys […]

[Read more →]

PowerAid Throttle Body Spacer Installation Instructions for 03-08 Dodge Ram 5.7L Hemi
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen the hose clamp and remove the air tube from the throttle body air box.
3. Disconnect the air temperature sensor connector attached to the air box.
4. Loosen the two bolts that secure the air box using a 10mm […]

[Read more →]

Pre-fit all pieces to the vehicle. Once you are assured that you have the right aero kit you may proceed. If you don’t, please call Stillen right away. We highly recommend using masking tape anywhere the aero kit may be touching the vehicle body to prevent scratches during the pre-fit. Do any sanding, filing, or […]

[Read more →]

Raising Vehicle
Removal of the front sway bar should be done at ride height, so it is recommended that the vehicle be raised by a flat alignment style rack, or place the front of the vehicle on ramps and securely block the rear wheels.
Remove front Splash Guard
To access the front sway bar you will need to […]

[Read more →]

INSTALLATION
1) Disconnect the vehicle’s negative battery cable.
2) Loosen the hose clamp where the rubber intake hose connects to the mass-air sensor.
3) On some vehicles with a manual transmission;you may need to unhook the vacuum pipe from the rubber hose junction.
4) Carefully remove the electrical plug connection from the mass-air sensor.
5) Unclip the airbox lid. Remove […]

[Read more →]

Pre-Installation:
1. Remove all stock intercooler pipes and intercoolers (Refer to Factory Service Manual for removal instructions)
2. Install Front Mount Intercooler. (Refer to FMIC installation section)
3. Unbolt Oil Cooler and move forward at least one inch.
a. Remove upper bracket
b. Bolt lower hole to existing hole where factory intercooler was.
c. Mark hole for upper side bracket hole
d. […]

[Read more →]