Automotive Manual, Car Parts and News

Before Starting Installation
1. Carefully read all warnings and instructions completely before beginning.
2. Verify all parts have been received in this kit by checking the parts list at the end of this document.
3. Only install this kit on the vehicle for which it is specified. If anytime during the installation you encounter something different from what […]

[Read more →]

This kit is used for 2004-2005 Nissan Titan 3 and should only be installed on a vehicle that is in good working condition. Before you install the kit, thoroughly inspect the vehicle for corrosion or deformation of the sheet metal around the factory body mounts. If the vehicle is suspected to have been in a […]

[Read more →]

The third-generation Mazda RX7 (FD3S) suffers from fuel starvation issues when driven aggressively, especially on vehicles with R-compound tires. This problem is caused by particularly wide and shallow fuel tank with an off-center pump location which is offset to the driver’s side. Under hard acceleration to the left, the fuel in the tank is forced […]

[Read more →]

This kit should only be installed on a vehicle that is in good working condition. Before you install the kit, thoroughly inspect the vehicle for corrosion or deformation of the sheet metal around the factory body mounts. If the vehicle is suspected to have been in a collision or misused, do not install this kit. […]

[Read more →]

The front fascia, lower grill, and tie down brackets are removed for baseplate installation. Lower grill will need to be trimmed or left out. Tie down brackets will not be reinstalled. No holes need to be drilled. The BX8869 is available for the vehicle. Attachment Tabs are 20 inches center to center and a height […]

[Read more →]

THE EDGE highly recommends use of part number EDG3-9290 (Adjustable Pan-rod Bar) if part number EDG3-3000 is used as the primary and only leveling kit for the vehicle. If this kit is being added to an existing kit that has been previously installed on the vehicle, continue with the following instructions without this recommendation.

[Read more →]

PREPARATION FOR INSTALLATION
1. Be sure that the vehicle is parked on level concrete and the parking brake is on.
2. Place stops in front of and behind rear tires.
3. Consult owner’s manual for proper lifting and wheel removal procedures before lifting front of vehicle.
4. Place jack stands under vehicle for added stability.

[Read more →]