Automotive Manual, Car Parts and News

1. Remove tailgate by disconnecting the tether cable and lifting the tailgate out at approximately a 45º angle. Reference the truck’s Owner’s manual.
2. Carefully remove the OEM tailgate pivot cups from the tailgate taking note of which side they belong on.
NOTE: On F-150 (FD80002) make sure the OEM left side pivot cup remains on the […]

[Read more →]

1. Remove tailgate by disconnecting the tether cable and lifting the tailgate out at approximately a 45º angle. (Reference the truck’s Owner’s manual).
2. Carefully remove the OEM tailgate pivot cup from the tailgate taking note of which side they belong on.
3. Remove latch pin bolt. A special wrench may be required.
4. Figures 1 through 5 […]

[Read more →]

The mounting procedure outlined below covers 1973 - 1993 Dodge W250 & W350 trucks. You will need to refer to the illustrations and familiarize yourself with each of the undercarriage components and their relative position to each other. Then proceed as follows:
1. Remove the Front Bumper and Front Bumper Mounting Brackets from the Frame Horns. […]

[Read more →]

Get ready to install coil spring leveling kit.
1. Lift front wheel assemblies.
a. If so equipped, remove two caps (4) from front wheels (5)
b. Loosen eight lug nuts (6) each from two front wheels (5).
c. Using a hydraulic jack, slowly lift front of vehicle so that two front tires (7) are three to five inches off […]

[Read more →]

DODGE S-2000 Spherical Roller Bearing mounted units incorporate a unique way of sealing the internal components of the bearing while still allowing a full + or - 1 degree of misalignment. The patented sealing system (Pat. #5,908,249) has proven effective, due to its constant contact pressure, in protecting the internal bearing components under maximum allowable […]

[Read more →]

Although this hitch is designed to safely tow its rated load, we recommend that you consult your vehicle owner’s manual for possible manufacturer’s recommendations or limitations. Always follow the manufacturer’s installation instructions and always install on the specified vehicle. Before installing hitch, check that the attachment points are in good condition. Failure to follow these […]

[Read more →]

Installation by a trained mechanic is recommended
Step 1: Position vehicle on a flat surface and lift vehicle by the frame so that the front wheels are off the ground. Use a floor jack and jack stands or a (2) two post lift if available. Next, locate the torsion key at the rear of the torsion […]

[Read more →]

Step 1: (A) Position truck on a flat surface and lift vehicle by the frame so that the front wheels are off the ground using a floor jack and jack stands or a (2) two post lift if available. Next locate the torsion key at the rear of the torsion bar under the cab of […]

[Read more →]

1) Front brackets are identical and are simply turned 180 degrees out so face of bracket is facing outside of truck.
2) Bars can be mounted either side and are identical.
3) Body mount torque is 65 ft.-lbs.
4) Holes in rocker panel are usually covered with black or grey tape from manufacturer

[Read more →]

Schefenacker recommends that this installation be carried out by a professional installer. Please read ALL the instructions and warnings thoroughly before installing theTelescopic Trailer Tow Mirrors.These mirrors are designed only for the vehicles listed on this page. Ensure that the fitting instructions are followed exactly, as failure to do so may result in incorrect installation, […]

[Read more →]