Automotive Manual, Car Parts and News

PROCEDURE
1. Begin installation by working on driver side of the vehicle starting at the front of the inner rocker panel.
2. Located on the inside as well as the bottom inner of the rocker panel you will see one thread hole and one thread stud for each mounting bracket refer to diagram 1. (Note all brackets […]

[Read more →]

The recommended push beam height for this undercarriage assembly is 10-1/2″ from the center of the push beam to level ground. DO NOT exceed 12-1/2″ in height for this undercarriage.
WARNING: Always perform vehicle undercarriage installations with the keys removed from the vehicle’s ignition. Properly tag the ignition switch to alert others work is being performed […]

[Read more →]

1) Remove front engine mount upper bolt with 14mm socket. The front engine mount is located on the timing cover side of the engine also known as the front of the engine.
2) Install the small torque link bracket as shown in picture. Use supplied M10 bolt and tighten to finger tight. A 13mm wrench or […]

[Read more →]

It is recommended that this set be professionally installed if you are unfamiliar with this type of work, and a factory service manual be purchased prior to performing any work on your vehicle for proper disassembly, reassembly and torque specs. These instructions are intended for bushing removal and install of Energy Suspension polyurethane bushings, once […]

[Read more →]

Powerchip technology enhances your Mazda to its ultimate level, delivering faster, smoother acceleration in all driving conditions. Whether you enjoy a leisurely weekend cruise or a hard racetrack drive – there is no easier and more effective way to release the potential from your Eunos 30X 1.8 V6. The following information is an overview of […]

[Read more →]

It is recommended that this set be professionally installed if you are unfamiliar with this type of work, and a factory service manual be purchased prior to performing any work on your vehicle for proper disassembly, reassembly and torque specs. These instructions are intended for bushing removal and install of Energy Suspension polyurethane bushings, once […]

[Read more →]

REAR DISC PAD INSTALLATION
1. Remove the parking brake cable.
2. Remove the bolt.
3. Slide the caliper to the position shown in the figure.
4. Remove the disc pads from the mounting support.
5. Remove the (shims and guide plates) . Store the removed parts away from dirt, as they will be reused.
6. Clean the exposed area of the […]

[Read more →]

Powerchip technology enhances your Mitsubishi to its ultimate level, delivering faster, smoother acceleration in all driving conditions. Whether you enjoy a leisurely weekend cruise or a hard racetrack drive – there is no easier and more effective way to release the potential from your Starion 2.0 Leaded Turbo. The following information is an overview of […]

[Read more →]

The AA cat back exhaust system is a fine exhaust system that will deliver a deeper sound, increased torque and horsepower. Many hours of design, testing and fitting were conducted for a clean fit and finish.
Locate the 6 pins that hold the rear valance along the back side lower edge. Remove them so that the […]

[Read more →]

On some vehicles the MSD Crank Trigger Kit may require slight modifications to accomodate special engine plates, pulley systems, etc.
INSTALLING THE PICKUP AND BRACKET
1. Mount the pickup holder onto the bracket using the two fine thread bolts (Figure 1). The pickup base will only install one way, do not try to force the bolts in, […]

[Read more →]