Automotive Manual, Car Parts and News

The mounting procedure outlined below covers the 2004 and Newer Nissan Titan trucks. You will need to refer to the illustrations and familiarize yourself with each of the undercarriage components and their relative position to each other. Then proceed as follows:
1. Begin by removing the front skid plate (if applicable). There should be (4) bolts […]

[Read more →]

Read The Snowplow Operators Manual Before Assembling This Kit.
1. Remove the front bumper from the truck by first detaching four plastic trim panel retainers from the blocker beam crossmember and disconnecting the engine block heater cord and fog light connectors, if equipped. Trim panel retainers will be reinstalled later. Unbolt six fasteners to remove the […]

[Read more →]

All hardware should be tightened only enough to ensure safety during assembly. Fully tighten all hardware after entire assembly is completed.
1. Remove the plastic air dam from the bottom of the front bumper. The air dam cannot be reinstalled when this mount kit is on the truck and should be returned to the vehicle owner […]

[Read more →]

For easier assembly and installation, vehicle and all snowplow components should be on a smooth, level, hard surface, such as concrete.
1. Remove license plate bracket and retain for vehicle owner. Remove bumper from bumper brackets. Retain fasteners.
2. Remove bumper brackets from frame. Retain fasteners.
Diesel applications: On these applications, you must first remove the top two […]

[Read more →]

1. Remove the bumper and adjustable bumper mount plates from the truck frame rail. NOTE: The fascia will need to be permanently removed or notched for reinstallation. Discard mount plate hardware.
2. Install the support arms (Ref 8 & 9) to the truck frame rail. The passenger side will install behind the front stabilizer bar and […]

[Read more →]

For easier assembly and installation, vehicle and all snowplow components should be on a smooth, level, hard surface, such as concrete.
1. Remove bumper from bumper brackets. Retain fasteners.
2. Remove bumper brackets from frame. Diesel and V10 applications: On these applications you must first remove the top two intercooler fasteners. Then push intercooler up and out […]

[Read more →]

Read instructions before assembling. Fasteners should be finger tight until instructed to tighten according to the torque chart. Use standard methods and practices when attaching snowplow including proper personal protective safety equipment.
MOUNT INSTALLATION
1. If the vehicle is equipped with a stamped-steel splash guard and/or tow hooks, remove them. Retain the splash guard, tow hooks, and […]

[Read more →]

The recommended push beam height for this undercarriage assembly is 10-1/2″ from the center of the push beam to level ground. DO NOT exceed 12-1/2″ in height for this undercarriage.
WARNING: Always perform vehicle undercarriage installations with the keys removed from the vehicle’s ignition. Properly tag the ignition switch to alert others work is being performed […]

[Read more →]