Automotive Manual, Car Parts and News

RSS Feed

Free PDF Download, Car Parts and Automotive News

1996-1999 Nissan Pathfinder (R50) Automatic to Manual Transmission Conversion Manual

December 19th, 2010 · No Comments

This manual will, in detail, give the information you will need to convert a 4×4 1996-1999 Nissan Pathfinder from an automatic transmission to a manual transmission. Having a manual transmission in your Pathfinder gives you more control, lower gears, and more power than you would have with an automatic. Other benefits include better gas mileage, [...]

[Read more →]


HD Standard Length SYE Kit for the NP241

December 6th, 2010 · No Comments

Installation Instructions for the NP241C or NP241DLD Transfer Case. This kit fits for Jeep, Chevy, Dodge.
Applications:
• Use for installing Dodge NP241 into Jeep TJ, YJ, XJ with original Jeep speedometer
• Install in existing Dodge NP241 (truck) with transfer case mounted speedo pickup
• Use for installing Chevy NP241 into Jeep TJ, YJ, XJ requiring Jeep style [...]

[Read more →]


1994-2002 Dodge Cummins 2 Low Unloc Differential Kit

December 4th, 2010 · No Comments

This kit is designed to allow the operator to manually disable the front wheel drive mechanism by holding the hubs in the free (2WD) mode with the transfer case in 4WD low range. By allowing the front wheels to be disengaged, maximum torque is available to the rear wheels. This will also allow for sharp [...]

[Read more →]


1992 Mitsubishi Mirage Auto Trans Overhaul

October 2nd, 2010 · No Comments

Transaxle 4-speed automatic transaxle is electronically controlled. Transaxle uses hydraulically operated clutches controlled by the Transaxle Control Unit (TCU). Transaxle consists of clutches, brake, kickdown band, planetary gear sets and transfer case (W4A32 and W4A33).
The TCU receives information from various inputs and controls solenoids on the valve body for different gear operation. Overdrive or 4th [...]

[Read more →]


97-2005 Jeep Wrangler TJ 4.0 Ultimate Suspension System

May 31st, 2010 · No Comments

This suspension system will enhance the off-road performance of your vehicle. It will handle differently, both on and off-road, from a factory equipped passenger car or truck. Extreme care must be used to prevent loss of control or vehicle rollover during abrupt maneuvers. Failure to drive this vehicle safely may result in serious injury or [...]

[Read more →]


Ford Quadra-Version Four-Wheel Drive Operating Instructions

January 20th, 2010 · No Comments

The vehicle should only be engaged in 4 Wheel Drive for off-road operation or when road or weather conditions create poor traction. When you are operating the vehicle on DRY roads keep the transfer case in 2H to prevent excessive tire wear and drive train damage.
ENGAGE FOUR WHEEL DRIVE WITH – MANUAL LOCK-OUT HUBS
1. Prepare [...]

[Read more →]


Dodge 4WD 29T NV4500 5 Speed To Advanced Ring

December 21st, 2009 · No Comments

When assembling the transmission to the transfer case, DO NOT FORCE the two gear boxes together. If the shaft is too long, there is the possibility of pre-loading the transmission bearings for premature failure. Take the extra time to make sure that the shafts do not bottom out internally. If there is an interference problem, [...]

[Read more →]


Jeep/Dodge Perm-Lok Installation Instructions

November 29th, 2009 · No Comments

These instructions have been designed for unaltered vehicles. Before you start, check for any variations. Each vehicle may dictate it’s own control mount and cable routing. Therefore, you will need to study the pictures and use your good judgement or seek professional help. Lift kits may govern how and where the cable is routed. Always [...]

[Read more →]


2000 Dodge Dakoda Installation Instructions

November 28th, 2009 · No Comments

Get ready to install the kit.
1. Remove the shift transfer case shift linkage.
a. If present on your vehicle, remove four bolts and skid plate from the frame under the transmission and transfer case.
b. Remove two rubber bushings and transfer case shift linkage from shift lever and transfer case.
2. Remove the front bumper.
a. Remove nine panel [...]

[Read more →]


Dodge 4×4 Posi-Lok Installation Instructions

November 26th, 2009 · No Comments

These instructions have been designed for unaltered vehicles. Before you start, check for any variations. Each vehicle may dictate it’s own control mount and cable routing. Therefore, you will need to study the pictures and use your good judgement or seek professional help. Lift kits may govern how and where the cable is routed. Always [...]

[Read more →]




?>